Table of Contents
Advertisement
Installation and Operation, cont'd
6" Deep Rack Shelf
Front false
faceplate
uses 2
screws.
Use 2 mounting holes on
opposite corners.
Mounting an MDA EQ on a 6-inch rack shelf
Furniture mounting
To furniture-mount the MDA EQ, use the optional under-desk
mounting kit (part #70-212-01), as follows.
Preparing the MDA EQ for under-desk mounting
If rubber feet were previously attached to the bottom of the
1.
unit, remove them.
2-4
VersaTools® MDA EQ Series • Installation and Operation
1/2 Rack Width Front False
Faceplate
(2) 4-40 x 3/16"
Screws
2
Attach the mounting brackets to the MDA EQ with the
provided machine screws as shown in the previous figure.
3.
Hold the unit with the attached brackets against the
underside of the table or other furniture. On the mounting
surface, mark the location of the bracket's screw holes.
4.
Drill 3/32" (2 mm) diameter pilot holes, ¼" (6.3 mm) deep
in the mounting surface at the marked screw locations.
5.
Insert #8 wood screws into the four pilot holes. Tighten
each screw into the mounting surface until slightly less
than ¼" of the screw head protrudes.
Align the mounting screws with the slots in the brackets
6.
and place the unit against the surface, with the screws
through the bracket slots.
7.
Slide the unit slightly forward or back, then tighten all four
screws to secure it in place.
Projector mounting
To projector-mount the MDA EQ, use the optional projector
mounting kit (part # 70-217-01) as follows.
Mounting
Bolt
Projector
Mounting
Bracket
Ceiling
Projector
Projector-mounting an MDA EQ
1.
If rubber feet were previously installed on the bottom of
the unit, remove them.
2.
Attach the mounting brackets to the MDA EQ with the
provided machine screws.
VersaTools® MDA EQ Series • Installation and Operation
2-5
Advertisement
Table of Contents
