Chapter 2: Connecting; Wall Outlet Cable; Standard Cable Box - Mitsubishi Electric WD-73727 Owner's Manual

Connecting a Wail Outlet Cable or Cable Box
Wail Outlet Cable
(can be used with a CabmeCARD
TM)
F_gure1
It is very important to connect the incoming came
for your primary viewing source to ANT-l, especiaHHy
for CabHeCARD
TM
use and to downHoad TV Guide On
Screen® Hisfings.
2.
3.
Connect the primary incoming coaxiaH Headcame to
ANT l/MAIN on the TV back pane[.
For an optional secondary antenna source, connect
an antenna (or cable) to ANT 2/AUX.
If you have subscribed to a CabHeCARD
TM
service,
the CabHeCARD can now be inserted into the
CabHeCARD SLOT. Using a Phillips screwdriver,
remove the CabHeCARD cover screws. Insert the
CabHeCARD, then replace the cover and screws. The
top of the card should face in the direction the CARD
TOP arrow indicates.
Additional CabHeCARD information is on page 23.
Detailed TV Guide On Screen information is in the
separate User's Manual.
Standard Cable Box
(cabUe box, other than an HDTV cabmebox; this setup
allows two-channel PIP)
Figure 2
3 coaxial cables and one two-way RF splitter are required.
These are not included with the TV.
Note: See page 30 to connect an HDTV came box.
1. Connect the incoming came to IN on an RF spHitter.
2. Connect one coaxiaH came from OUT on the RF
spHitter to ANT-1 MAiN on the TV back pane[.
3. Connect one coaxiaH came from OUT on the RF
spHitter to IN on the standard came box.
4. Connect one coaxiaH came from OUT on the came
box to ANT-2 AUX on the TV back pane[.
5. After the came box is connected to ANT-2 AUX as
shown, use the NetCommand menu Change option
to change the defauHt connection for the came box,
go to the RF Connection for CaMe screen and do the
foHHowing:
a. Check the RF check box.
b. For antenna, seHect ANT-2.
c. For ChanneH, seHect the channeH to which the TV
must be tuned for your came box. The defauHt
channeH is 3.
When this setup is compHete, you can use the TV remote
controH to change channeHs on the came box.
ii!ii_ii!!i_i_i:!iiiiii :,¸ i _ _i::,!i!!ji!::i:i:i!_ii!!i?!_!i!_ ¸lii_¸¸
3. Cab_eOARD TM SLOT
(cover removed}
1. Primary Wall
Outlet Cable
2. Optional Secondary
Antenna or CabEe
Figure I. Waft Outlet CaMe
__h the TV. They are
TV back
paneH
section
To ANT 2!AUX
E booming -'_
Figure 2. Connecting a CaMe Box
Note: To use a cable box connected to ANT-2 as shown
above, you must make the noted NetCommand changes.
The changes are required to change the NetCommand
cabie_box default connection (Componentq) to the
actual connection (ANT-2).
24 Chapter 2. Connecting