Chapter 7: Troubleshooting - Mitsubishi Electric WD-73727 Owner's Manual

GeneraJ TV Operation
14
Suggested Somution
, • Remote has not been set up for NetCommand@use.
The incorrect manufacturer was selected during setup. Select the Change setting
from the Setup menu and then the device to display the manufacturer selection.
Change if necessary.
The device is not supported and keyshave not been learned.
, • The requested function is not supported by NetCommand. Verifythat the
function is supported or keysare learned.
The IR emitter is incorrectly placed. Make sure the IR emitter is facing the IR
sensor inthe device.
, • The JRemitter is not plugged into the IR emitter Output NetCommand.
The IR emitter is facing the TVscreen, causing double signals. Be sure that the IR
emitter cannot send to the T\L
15. The TV Speaker icon or A/V Receiver icon ls Select the Change setting from the Edit NetCommand menu, and then
grayed out and not sebctabb, select the device (for example VCR). Once the Connection screen is
displayed, check if the audio check box is selected for the TV input
and/or AVR input.
16. Devices are grayed out in the Device Selection * A recording is in progress. Cancel the recording to select the device.
menu or the PiP Selection menu. , * Digital channels,digital devices, memory cards, and PCs cannot display in the
PiR
17. Cannot see the A/V Receiver menu. The A/V Receiver is not connected to any input of the TV. To check the
A/V Receiver menu, temporarJIy plug into an unused input of the TV.
Then select Review from the Setup Menu, turn the input On to view the
A/V Receiver menu.
18. The REC button is not working, or, on the , • The device, such as a DVDplayer, does not support recording.
Transport menu, the record key ls grayed out and • Recordings cannot be initiatedfrom the Transport menu when using an IEEE
not available. 1394 device. Press REC instead. The Record menu displays allowing setup of a
recording.
19. When ChannetView
TM
list is dispIayed, information AvaiIabb information is sent from the broadcaster or cable provider. No
appears incomplete other data is available.
20. Program to be recorded was correctly selected The broadcaster supplied program information that was incorrect and/or
from ChannetView, however, incorrect program was changed after a recording was added to the Record List.
was recorded.
21. incomplete ChanneWiew program recorded. Recording device may lack sufficient blank space to make a full
recording.
22. ChannelView program recording failed. , * Connection and compatibility issueswith IEEE1394 (FireWire@) digital devices.
This may includetoo many Firewiredevices in use at one time, or the recording
device not understanding the record command.
, * Televisionlost power long enough to lose current clock time.
Analog VCRpower was left off.
23. TV is not responding after pulJlng out a memory Press STOP or wait until playback ls complete before removing memory
card during playback, card.
24. TV can't play or stop a memory card. , • NetCommand was not set up. Without NetCommand enabled, you can only use
ENTERto play and CANCELon the TV remote to control the memory cards. See
Appendix D for programming the remote control.
, • Turnthe TV off and then back on.
25. Can't see a thumbnail picture in the JPEG menu, File does not meet file standards for playback.
or can't see a track/song name in the Playtist
menu.
A device does not respond to button presses
from the remote.
Chapter 7. Troubleshooting 93