Front And Rear Panels; Front Faceplate; Rear Connectors - Extron electronics APP User Manual

Controls and Installation

Front and Rear Panels

Front faceplate

1
2
100%
UNITY
6
50%
GAIN/PEAKING
Figure 2-1 — P/2 DA2 WM faceplate features
Both WM and EC models have the same front and
rear panel connectors and features. See figure 2-2.
2-color power/signal LED — lights amber to indicate
1
power On only; lights green to indicate power On
with video signal present.
Audio input jack — 3.5 mm stereo input
2
VGA input connector — HD 15-pin male analog
3
video input connector
Buffered local monitor output — HD 15-pin female
4
for output to a local monitor
ID bit termination DIP switches — provides proper
5
ID bit termination for a laptop computer that is not
attached to a local monitor.
3-position gain/peaking switch — compensates for
6
cable capacitance and resistance due to long cable
runs; position switch for best image on the output
display device.
100% – increases the output signal level and adds
100% of the maximum peaking to the signal
2-2 P/2 DA2 WM/EC Controls and Installation
AUTO POWER
5
4
3
Unity – output signal level is same as that of input
with no added peaking
50% – increases the output signal level and adds
50% of the maximum peaking to the signal
If the edges of the image seem to exceed their
boundaries, or if thin lines and sharp edges look
thick and fuzzy, try changing the level/peak setting.
1
AUTO POWER
2
GAIN/
PEAKING
6
3
Figure 2-2 — P/2 DA2 EC faceplate features

Rear connectors

1 2
NC
12-24V AC/DC L R
3
Figure 2-3 — P/2 DA2 WM rear connectors
Power input — 12 - 24 VAC or DC (captive screw
1
connector). The center pole contains no conductor.
Connect the conductors to the outer two poles only.
Positive
N/C
Negative
Audio output — 3.5 mm captive screw stereo output
2
VGA output — HD 15-pin female analog video
3
output connector
P/2 DA2 WM/EC Controls and Installation
P/2 DA2 EC
ID PINS
5
4
NC
12-24V AC/DC L R
2-3