Level The Washer - Maytag BRAVOS MTW6600TQ0 Use & Care Manual

Excessive Weight Hazard
Use two or more people to move and install washer.
Failure to do so can result in back or other injury.
One washer foot has been installed at a different height on your new washer. The other three
feet were preset at the factory. Properly leveling your washer will minimize noise and
vibration.
1. Slide the washer to its final location.
2. Push on upper front panel to be sure the washer is on its rear feet.
4. Check the levelness of the washer by first placing a level oil the lid near the console.
Next, place the level on the side of the washer in the crease between the top of the
washer and the cabinet.
Level the front.
I
3.
lower right front foot until it contacts tile floor. By hand, firmly rotate foot as much as an
additional 1V2 turns. The other three feet have been preset at the factory.
[ew_l the side.
5. If the washer is not level, move the washer out slightly, tip back, prop up the front of the
washer on a wood block. Adjust the feet up or down as necessary by twisting the feet.
Repeat steps 1 through 4 until washer is level.
6. Use a 9/16" or 14 mm open-end wrench to turn the Iocknut counterclockwise on the foot
tightly against the washer cabinet.
IMPORTANT." if the Iocknut is not tight against the washer cabinet, the washer may
vibrate.
11