Secure The Drain Hose; Check For Leaks - Maytag BRAVOS MTW6600TQ0 Use & Care Manual

Connect the inlet hoses to the washer
COLD
A. Hot water inlet valve
B. Cbld water inlet valve
1. Attach the hot water hose to the inlet valve labeled hot.
2. Attaching one hose coupling first makes it easier to tighten the connection with pliers.
3. Screw on coupling by hand until it is seated on the washer.
4.
Using pliers, tighten the coupling with an additional two-thirds turn.
NOTE: Do not overtighten or use tape or sealants on the valve. Damage to the valves can
result.
Check for leaks
• Turn on the water faucets and check for leaks. A small amount of water might enter the
washer. You will drain this in a later step.
NOTE: Replace inlet hoses after 5 years of use to reduce the risk of hose failure. Record
hose installation or replacement dates for future reference.
• If you connect only one water hose, you must cap off the remaining water inlet port.
• Periodically inspect and replace hoses if bulges, kinks, cuts, wear, or leaks are found.
1. Drape the power cord over the console.
2. Remove any cardboard used to move washer.
Zg>
Beaded de strap
3. Fasten the drain hose to the laundry tub leg or drain standpipe with the beaded tie strap.
See view A or B.
C
If the washer faucets and the drain standpipe are recessed, put the formed end of the drain
hose into the standpipe. Tightly wrap the tie strap around the water inlet hoses and the
drain hose. See view C.
5. Attach the cold water hose to the inlet valve labeled cold.
6. Screw on coupling by hand until it is seated on the washer.
7. Using pliers, tighten the coupling with an additional two-thirds turn.
NOTE: Do not overtighten or use tape or sealants on the valve. Damage to the valves can
result.
10