Level The Washer - Maytag 3RMTW4905TW0 Use & Care Manual Installation Instructions

3. Wrap the drain hose to the laundry tub leg, drain standpipe or inlet hoses, with the beaded
tie strap. Push fastener into the nearest hole in the beaded tie strap. See view A or B.
A
If the washer taps and the drain standpipe are recessed, put the formed end of the drain
hose into the standpipe. Tightly wrap the tie strap around the water inlet hoses and the
drain hose. See view C.

Level the Washer

Properly leveling your washer avoids excessive noise and vibration.
Install the Front Leveling Feet
1. Prop up the front of the washer about 10.2 cm (4") with a wood block or similar object.
The block needs to support the weight of the washer.
A. Threaded holes for feet
12
B C
10.2 cm
(4")
A
2. Screw the locknut onto each foot to within 2.5 cm (1") of the foot base.
3. Screw the feet into the threaded holes at the front corner of the washer until the nuts
touch the washer. Twist the feet to install.
NOTE: Do not tighten the nuts until the washer is level.
4. Tilt the washer back and remove the wood block. Gently lower the washer to the floor.
Steps in Final Location
1. Slide the washer to its final location.
2. Tilt the washer forward until the rear of the washer is at least 10.2 cm (4") off the floor. You
may hear the self-adjusting rear feet click into place. Lower the washer to the floor.
A. Self-adjusting feet
2.5 cm
(1")
10.2 cm
(4")
A