Level Washer - Maytag MVWP575GW Installation Instructions Manual

5.
Secure drain hose
Laundry Tub Standpipe
4.5"
4.5" 4.5"
(114 mm)
(114 mm)
Secure drain hose to laundry tub leg, drain standpipe, or inlet
hoses for wall standpipe with cable tie.
It is the responsibility of the installer to install and secure the
drain hose into the provided plumbing/drain in a manner that
will avoid the drain hose coming out of or leaking from the
plumbing/drain.

LEVEL WASHER

IMPORTANT: Level washer properly to reduce excess noise
and vibration.
1.
Check levelness of washer
Place level here
Move the washer to its final location. Place a level on top
edges of washer. Use side seam as a guide to check levelness
of sides. Check levelness of front using lid, as shown. Rock
washer back and forth to make sure all four feet make solid
contact with floor. If washer is level, skip to step 3.
Not Level
8
Wall
(113 mm)
(114 mm)
Place level here
LEVEL Not Level
2.
Adjust leveling feet
4.5"
4.5"
Jam nut
If washer is not level:
Use a 9/16" or 14 mm open-end or adjustable wrench to turn
jam nuts clockwise on feet until they are about 1/2" (13 mm)
from the washer cabinet. Then turn the leveling foot clockwise
to lower the washer or counterclockwise to raise the washer.
HELPFUL TIP: You may want to prop up front of washer
about 4" (102 mm) with a wood block or similar object that
will support weight of washer.
3.
Tighten leveling feet
Jam nut
When washer is level, use a 9/16" or 14 mm open-end
or adjustable wrench to turn jam nuts counterclockwise
on leveling feet tightly against washer cabinet.
HELPFUL TIP: You may want to prop the washer
with a wooden block.