KitchenAid KBNU367T Manual page 21

3. To load the spit rod, slide one of the rotisserie forks onto the
spit rod with prongs facing inward.
4. Push spit rod through the center of the food, then slide
second rotisserie fork into position.
5. Center the food and rotisserie forks on spit rod and tighten
wing nuts on the rotisserie forks. If necessary, secure loose
food portions with butcher's string only.
6. Once the food is positioned on spit rod, place pointed end of
rod through the hole in the left side of the grill and into the
rotisserie motor, then lower the notched end of the spit rod
onto the support bracket on the opposite side.
7.
A. Pointed end of spit rod
B. Notched end of spit rod
Check that food is centered with the rotisserie burner. If not,
loosen wing nuts, reposition food and retighten wing nuts.
3. When the rotisserie burner lights, continue to hold the knob in
for another 10 seconds, then release the knob and burner will
stay lit.
IMPORTANT: If the rotisserie burner does not light immediately,
turn the burner knob to OFF and wait 5 minutes before relighting.
Manually Lighting the Rotisserie Burner
1. Do not lean over the grill.
2. Remove the manual lighting extension (see following
illustration) and attach a match to the split ring.
Freestanding grills -
right-hand cabinet drawer
Built-in grills - right-hand
side flange
3. Strike the match to light it.
4. Gently hold the lit match close to the rotisserie burner.
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
5.
A
B
A. Lighting extension
B. Rotisserie burner
Push in and turn the control knob to LITE/HI. Hold this knob
in for 10 seconds after the burner is lit. You will see the igniter
glow until after the knob is released.
8. Plug into a grounded 3 prong outdoor outlet.
9. Turn on the rotisserie motor and light the rotisserie burner.
See the following "Lighting the Rotisserie Burner" section.
Lighting the Rotisserie Burner
1. Do not lean over the grill.
2. Push in and turn the control knob to LITE/HI. You will see the
igniter glow.
6.
IMPORTANT: If the rotisserie burner does not light
immediately, turn the rotisserie burner control knob to "OFF"
and wait 5 minutes before relighting.
Remove the match and replace the manual lighting extension
inside the cabinet drawer.
I
m
21