Setting The Clock - Kenmore ELITE 790.4907 Series Use & Care Manual

Setting the Clock
Setting the Clock
The _ pad is used to set the clock. The clock may be set for 12 or 24 hour time of day
operation. The clock has been preset at the factory for the 12 hour operation. When the
range is first plugged in, or when the power supply to the range has been interrupted, the
timer in the display will flash with "PF" (power failure, See Figure 1 ).
When PF appears in the display, press @. No sound will be heard, but after 10 seconds
a beep will sounds and PF will disappear.
INSTRUCTIONS PRESS
To set the clock (example below for 1:30)
1. Press _. "CLO" will appear in the display (Figure 2).
2.
Press _ _ (0_
pads
to set the time of day to 1:30
"CLO" will stay in the display. Press _. "CLO"
(Figure 3).
will disappear and the clock will start (Figure 4).
Changing between 12 or 24 hour time of day display
1. Press and hold _ for 7 seconds (Figure 3). After 7 seconds,
"12Hr" (Figure 5) or "24Hi" (Figure 6) will appear in the display
and the control will beep once.
2. Press _ to switch between the 12 and 24 hour time of day
display. The display will show either "12Hr" (Figure 5) or "24Hr"
(Figure 6).
3. Press _ to accept the change or press @
to reject the
change.
4. Reset the correct time as described in To set the Clock above.
Please note that if the 24 hour time of day mode was chosen, the
clock will now display time from 0:00 through 23:59 hours.
Q
OQQ
Q
for 7 seconds
Q
Figure 1
DISPLAY
Figure 2
Figure 3
Figure 4
Figure 5
Figure 6