Setting The Clock - Kenmore 790.4773 Series Use & Care Manual

Setting the C ock
Note: The time of day must first be set in order to operate the oven.
To Set the C_ock
When the range is first pUugged in, or when the power suppUy to the appliance has been interrupted, the dispUay wHU
flash "12:00" and PF (power failure) appears in the display.
_ once (do not hoUdpad down).
1. Press
2. Within 5 seconds, press and hoUdthe A or v until the correct time of day appears in the display.
3. Press _ to accept the change, if the pad is not touched the change wHU be accepted after 5 seconds.
Note: The dock cannot be changed during any timed bake or serf-dean cycUe.
Changing Between 12 or 24 HourTime of Day Display:
Press and hoUd_(_"} for 7 seconds. After 7 seconds, "12Hr" or "24Hr" wHU appear in the dispUay and the controU wHU
1.
beep once.
2. Press A or v to switch between the 12 and 24 hour time of day display. The display wifl show either"12H¢' or"24H¢'.
3. Wait 5 seconds to accept the changes or press _to cancel and return to the time of day display.
4,
Reset the correct time as described in To set the Ctock above. Please note that if the 24 hour time of day mode was ii.............
chosen, the clock will now display time from 0:00 through 23:59 hours, iiii:i:i', I
To Set the Minute Timer
1. Press @.
2. Press the _ to increase the time in 5 second increments. Press and hold ._. pad to increase the time faster. The
timer can be set for any amount of time from 5 seconds to 11 hours and 50 minutes.
3. The display shows the timer countdown in seconds when you set the minute timer for less than 59 minutes. When
the minute timer is set for more than 1 hour the display shows the timer countdown in minutes.
When the set time has run out, the timer will beep until _ is
4.
pressed.
Note: The minute timer does not start or stop cooking. It serves as an extra timer in the kitchen that will beep when the
set time has run out. The minute timer can be used alone or during any of the other oven functions. When the minute
timer is in use with any other mode, the other mode countdown will be shown in the display. To view the minute timer
down, press _. count
To Change the Minute Timer while it is in use:
While the timer is active and shows in the display, press _ and hold the _ or v pad to increase or decrease the time.
To Cancet the Minute Timer before the set time has run out: Press _ twice and press {_ to return to time of
day display.
To Set Add 1 Minute Feature
The _,,_ ADD 1 MINUTE pad is used to set the Add 1 Minute feature. When the _ pad is pressed, 1 minute is
v
added to the Minute Timer feature if this feature is already active. If the Minute Timer feature is not active and the
_pad is the Minute Timer feature will become active and will down from minute. For
pressed, begin counting
1
further information on how to set the Minute Timer feature see To Set the Minute Timer instructions above.