Setting The Clock - Kenmore ELECTRIC BuILT-IN OVEN Use & Care Manual

Setting the Clock

Note: The time of day must first be set in order to operate the oven.
To Set the Clock
When the range is first plugged in, or when the power supply to the appliance has been interrupted, the display will flash
"12:00".
1. Press once (do not hold pad down).
2. Within 5 seconds, press and hold the
3. Press once to accept the new time of day. If the pad is not pressed, the timer will return automatically to the new
time of day after 7 seconds.
Note: The clock cannot be changed during any timed bake, delayed time bake, self-clean cycle or delayed self-clean
cycle.
Changing Between 12 or 24 Hour Time of Day Display
1. Press and hold
once.
2. Press or to switch between the 12 and 24 hour time of day display. The display will show either "12Hr" or
"24Hr".
3. Wait 5 seconds or press
4. Reset the correct time as described in To set the Clock above. Please note that if the 24 hour time of day mode was
chosen, the clock will now display time from 0:00 through 23:59 hours.
To Set the Timer
1. Press .
2. Press the to increase or
time from 1 minute to 11 hours and 59 minutes.
3. The display shows the timer countdown in minutes if more than 1 hour remains. When less than 1 hour remains, the
display will countdown in seconds.
4. When the set time has run out, the timer will beep 3 times. It will continue to beep 3 times every 8 seconds until
is pressed.
Note: The indicator light located above the
Note: The timer does not start or stop cooking. It serves as an extra timer in the kitchen that will beep when the set time
has run out. The timer can be used alone or during any of the other oven functions. When the timer is in use with any other
mode, the timer will be shown in the display. To view other functions, press the function pad for that mode.
To Cancel the Timer before the set time has run out: Press
To Set Add 1 Minute Feature
The pad is used to set the Add 1 Minute feature. When the
feature if this feature is already active. If the Timer feature is not active and the
will become active and will begin counting down from 1 minute.
or
for 7 seconds. After 7 seconds, "12Hr" or "24Hr" will appear in the display and the control will beep
to return to the time of day display.
to decrease the time in one minute increments. The timer can be set for any amount of
until the correct time of day appears in the display.
pad will glow while the minute timer is active.
.
pad is pressed, 1 minute is added to the Timer
8
pad is pressed, the Timer feature