Setting The Clock - Kenmore 790.47735 Series Use & Care Manual

Setting the Clock

Note: The time of day must first be set in order to operate the oven.
To Set the Clock
The pad is used to set the clock. The clock may be set for 12 or 24 hour time of day operation. The clock has been
preset at the factory for the 12 hour operation. When the appliance is first plugged in, or when the power supply to the
appliance has been interrupted, the timer in the display will flash along with "PF" (power failure).
When PF appears in the display and 12:00 is flashing, press
To set the clock
1. Press pad. "CLO" and the current time of day will appear in the display.
2. Press or pad to set the correct time of day. Wait 5 seconds. The new time of day will appear in the display.
Changing Between 12 or 24 Hour Time of Day Display:
1. Press and hold
and "12h" or "24h" will appear in the display.
2. Press or pad to switch between the 12 and 24 hour time of day display. The display will show either "12h" or "24h".
3. Wait 5 seconds to accept the change or press
4. Reset the correct time as described in To set the Clock above. Please note that if the 24 hour time of day mode was
chosen, the clock will now display time from 0:00 through 23:59 hours.
To Set the Minute Timer
Timer
The pad controls the Timer feature. The Timer serves as an extra timer in the kitchen that will beep when the set time
Set/Off
has run out. It does not start or stop cooking. The Timer feature can be used during any of the other oven control functions,
except during a self clean operation.
To set the Timer
Timer
1. Press pad. "--:--" will appear and "TIMER" will flash in the display.
Set/Off
2. Press or pad to set the desired time in the display. Wait 5 seconds and the time will begin to countdown with
the set time and "TIMER" will stay in the display.
3. When the set time has run out, "End" and "TIMER" will show in the display. The clock will sound with 3 beeps every
Timer
7 seconds until
Set/Off
To cancel the Kitchen Timer before the set time has run out: Press
day.
To Set Add 1 Minute Feature
Add 1
When the pad is pressed, 1 minute is added to the Minute Timer feature if this feature is already active. If the
Minute
Minute Timer feature is not active and the
begin counting down from 1 minute.
pad for 7 seconds. "CLO" and the current time of day will appear in the display. A beep will sound
pad is pressed.¸
Add 1
pad is pressed, the Minute Timer feature will become active and will
Minute
STOP
pad. A beep will sound and PF will disappear.
Clear
STOP
pad to reject the change.
Clear
Timer
Set/Off
9
pad. The display will return to the time of