Navman iCN 630 User Manual page 60

ý
ý
ý
ý
ý
60
The iCN Desktop application will not allow me to load any more maps into my unit.
What can I do?
The iCN 630 unit has 64 Mbytes of internal memory available for storing maps. It is likely that
you have used up all this memory. To store more maps, choose one of the following:
• Delete a map that you do not require any more. For information on deleting maps,
refer to Section 3 Installing Software and New Maps – Installing Maps. Remember
that you can back up Settings, Shortcuts and Favourites to your PC first if you
wish to load a new set of maps.
• Purchase an SD or MMC memory card. These cards are available from your retailer
in a number of sizes – the recommended size to use is 128 Mbytes or 256 Mbytes.
The memory card plugs into the top of your iCN 630 unit, and gives you more
memory to store additional maps.
There are no audible instructions when I am driving to my destination –
What could be wrong?
• It is likely that the volume is turned down. Hold down the volume + button on the
right hand side of your unit to increase the volume. Remember, if you give the
volume button a short press, the very next instruction will be repeated.
My passenger often programs in our destination as I drive. Can I turn off the Driver
Protection screen?
• Yes – this screen can be disabled in the User Settings Menu. From the Main Menu,
select Settings, then User. Make sure that the check box labelled “Driver Protection -
Warn driver when operating unit” is not ticked.
The tutorial keeps running every time I start up my unit – can I turn it off?
• Yes – the tutorial can be disabled in the User Settings Menu. From the Main Menu,
select Settings, then User. Make sure that the check box labelled “Tutorial – Show at
startup” is not ticked.
My unit will not start up – what should I do?
• Check that you have followed the instructions in Section 3 Installing Software and
New Maps correctly. If your unit still does not run, take the unit to your retailer.
NAVMAN iCN 630 user manual-ver 0.12