Automatic Route Simulator - Navman iCN 630 User Manual

13
Press ESC at any
time to return to
the automatic Map
Browser screen.
If you don’t want to
use the Map Browser
screen to select
your destination,
use one of the other
methods described
in Section 7 Setting
Your Destination.
54

AUTOMATIC ROUTE SIMULATOR

The automatic route simulator allows you to program a route without a GPS fix (for example,
from inside a building), and view the route without going anywhere.
To use the auto simulator, you must first set a departure point and a destination. There are
many ways to do this, but here is an example of one way you can set up the auto simulator.
1 From the Main Menu, select SETTINGS, then USER.
2 Go to the Settings - GPS screen by pressing
Simulate box.
3 Return to the Main Menu, and select MAP.
4 Press OK to display gridlines – you are now in the manual Map Browser screen.
5 Use the 8-way toggle button to position the intersection of the gridlines over the
DEPARTURE point that you require. When the gridlines are over a street, the street name
is shown along the bottom of the screen.
6 Press OK to select the location. The address details are automatically displayed.
7 Select START to program this location as your departure point.
8 You are then returned to the Map Browser screen. Press OK to display gridlines.
9 Again, use the gridlines to select the DESTINATION point that you require.
10 Press OK to select the location. The address details are automatically displayed.
11 Select GO to start the auto simulator.
12 To stop the auto simulator, press MENU/Power
Select CANCEL ROUTE.
or selecting Page Fwd. Enable the Auto
to return to the Main Menu.
NAVMAN iCN 630 user manual-ver 0.12