Suction Or Adhesive Mount To Dash - Navman iCN 630 User Manual

ý
To remove the suction
cup, pull the lever up.
Release the suction
using release tab.
21

Suction or Adhesive Mount to Dash

1 Choose a position on the dash where the iCN 630 will be clearly visible by the driver.
Follow the safety guidelines at the front of this manual to ensure that the unit does not
obstruct the view of the driver, or interfere with the operation of any airbags and safety
devices in the vehicle.
2 Make sure that both the dash and the suction cup are thoroughly clean.
3 Suction Mount: if the location you have chosen is flat enough, you can simply use the
suction cup to mount the unit directly onto the dash.
4 Adhesive Mount: If the location you have chosen is not suitable to use the suction cup
alone, stick the sucker pad down first to give a flat surface. Do this by removing the
protective layer from the adhesive tape on the underside of the sucker pad, and pressing
the sucker pad firmly down for 30 seconds in the desired position on the dash.
NOTE: this is a permanent solution – the adhesive tape and sucker pad cannot be
removed from the dash once fixed.
5 Hold the suction cup firmly against the dash or centrally on the sucker pad, and press the
lever down until it snaps shut.
6 The ball foot should now be securely fixed. Slip the locking nut loosely over the ball foot,
with the flat side facing upwards.
Locking nut
Suction cup
7 Snap the socket clip onto the ball foot.
Make sure the
short side of
the socket clip
is on top
8 Adjust the position of the socket clip, so that the unit will be clearly visible by the driver.
9 Wind the locking nut onto the thread of the socket clip until firm.
Lever
Sucker pad
Push the
socket clip onto
the ball until it
clicks
NAVMAN iCN 630 user manual-ver 0.12