Navman iCN 630 User Manual page 20

To unclip the iCN 630
unit from the mounting
bracket, press down on
the back of the upper
plastic clip to release the
top of the unit, then lift
the unit out of the
bottom two slots.
In vehicles where
auxiliary power is
permanently on, the
unit can be switched
on and programmed
as soon as the power
adaptor is connected.
Switching the engine on
will not reset the unit.
20
6 Snap the socket clip onto the ball foot.
Push the socket
clip onto the ball
until it clicks.
7 Adjust the position of the socket clip, so that the unit will be clearly visible by the driver.
8 Wind the locking nut onto the thread of the socket clip until firm.
9 Snap the iCN 630 unit onto the socket clip. First, position the two locating tabs on the
underside of the unit into the corresponding slots on the socket clip. Then snap the upper
side of the unit into the clip.
10 Flip the aerial outwards so that the aerial is pointing horizontally.
Aerial points
up and out
11 Plug the power cable into the socket on the left hand side of the unit.
12 Plug the other end of the power adaptor into the vehicle’s cigarette lighter socket.
13 Make sure that the unit is positioned such that the aerial has a clear view of the sky.
14 In most vehicles, you will need to have the engine idling in order to program your route
into the unit. While you can switch on the unit with just the auxiliary power on (i.e. your key
in the Auxiliary ON position), turning the key to switch on the engine may interrupt power
to the unit and your programmed route will be saved for re use. It is recommended that
you program your route with the engine may already idling, but with the automatic shift of
your car in ‘Park’ and the handbrake applied.
Make sure the short
side of the socket
clip is on top.
Wind locking nut
onto thread
NAVMAN iCN 630 user manual-ver 0.12