Figure 3-19 Installing The Device - NEC Direction T-Series Manual

2. Remove the access cover.
3. Remove and label any cables that interfere with installing the device.
Remove the front panel.
4.
Remove the plastic blank panel. If you are installing a hard drive, keep the panel
5.
handy.
6. Remove the metal slot cover by carefully pressing it until it breaks away from the
chassis. Be careful of sharp edges.
7. From the front of the system, slide the device, connector end first, into the
device slot.
NOTE: To easily access device connectors for
cabling, do not insert a 5 1/4-inch device all the
way into the slot.
8. Connect the device cables (see "Cabling Storage Devices").
Align the holes in the device with the holes in the chassis.
9.
Secure the device with the screws that came with the device (see Figure 3-19).
10.

Figure 3-19 Installing the Device

Option Installation 3-23