Protecting The Cooktop; Display - Kenmore 911.95475 Owner's Manual

Protecting the Cooktop
o Do not slide cookware across your
cooktop
, Do not use a dish towel or sponge
to clean or wipe your cooktop
• Do not use scouring powders or
plastic, nylon or metal cleaning
pads on your cooktop
• Do not apply your cooktop cleaning
creme to the cooktop surface if the
surface is hot
o Read the instruction label on the
cooktop cleaning creme bottle
before attempting to clean the
surface of your cooktop.
o After cleaning the cooktop surface,
be sure to wipe off any residue with
a dry paper towel that may be left
from the cleaning creme
o For major spills, turn the surface
control knob to OFF Use a dry
paper towel to wipe up spill, then
use a razor scraper (held with a
potholder) at a 300 angle against
the surface of the cooktop to
scrape remaining spill from the hot
cooking zone
OPERATION
r
CAUTUON: When the
surface controls are
turned off, the Hot
Surface mndicator
light will remain lit until the
cooktop surface has cooled
to approximately 150°F, The
glass ceramic surface will
retain heat after the
indicator light goes out. Use
caution until the cooktop
surface has had time to cool.
.w,...J
To remove the adhesive left from
packaging tape, use household
dishwashing liquid, mineral oil or
cooking oil With a soft cloth rub into
the area and allow to soak Rinse and
dry welt Repeat procedure using an
appliance polish to insure no damage
is done This should be done
before the range is turned on
for the first time, The tape
cannot be removed once the
range has heated, Packaging
tape may be found in the following
areas. Cooktop surface, Door Handle,
Control Panel area, Door Trim and
Oven area
° Do not cook directly on the surface
of the glass
, Do not use the cooktop as a cutting
board
7