Self-Cleaning Cycle; Broiler Pan And Grid - Kenmore 911.95475 Owner's Manual

Self-Cleaning Cycle
CARE ANDCLEANING
1. Remove the broiler pan and grid,
oven racks, utensils and any foil
that may be in the oven
2. Soil on the front frame, 1" inside
the oven, and outside the door
gasket will need to be cleaned
by hand
Front Frame
Ooor Gask;t
--_'_ Door Liner
Clean these areas with hot water,
soap-filled steel wool pads or
cleansers such as Soft Scrub ® to
remove any soil Rinse well with clean
water and dry
8. Wipe up any heavy spillovers on
the oven bottom
4. Do not clean the door gasket The
fiberglass material of the oven
door gasket cannot withstand
abrasion It is essential for the
gasket to remain intact If you
notice it becoming worn, frayed or
displaced on the door, it should be
replaced
The door gasket is designed to have
a 5-6" gap at the bottom of the door.
This allows for proper air circulation
Door Panel Gasket
Door Liner
tt is normal for your oven door to give
the appearance of not having a good
seal against the range This is due to
the gasket. The location of the gasket
on the oven door maintains a good
seal and prevents any heat loss
_ tensils should never
be left in the oven
during a self-clean
cycle,
The oven racks may be
cleaned during the self.
clean cycle, but will lose
their luster and become hard
to slide, if you choose to
leave them in during the
cycle, wiping them down
with vegetable oil after the
cycle wil! help them slide
easier.
For the first clean cycle,
vent the room with an
opened window or hood
vent. This will reduce the
odor produced when heating
new parts,
18