GE JGBP36 Owner's Manual & Installation Instructions page 14

Using the oven.
To avoid possible bums, place the racks in the desired position before you turn the oven on.
The ovenhas 5 rack positions.
It also has a special low rack position (R)
for extra largeitems, suchas a large
turl<ey.
Before you begin...
The racks have stop-locks, so that when
placed correctlg on the rack supports
(Athrough E),theg will stop before coming
completelg out, and will not tilt.
When placing and removing cookware
pull the rack outto the bump on the rack
support.
To remove e reck, pull it toward gou, tilt the
front end up and pull it out.
To replece, place the end of the rack (stop-
locks)on the support, tilt up the front and
push the rack in.
NOTE:Therock is not designedto slide out at
the special low rock (R)position.
Plasticitems on the cool<top may melt
if left tee closeto the vent.
Ventappearance and locationvary.
Oven Vent
Your oven is vented through ducts at the rear
of the range. Do not block these ducts when
cooking in the oven-it is important that the
flow of hot air from the oven and fresh air
to the oven burner be uninterrupted. Avoid
touching the vent openings or nearbg
surfaces during oven or broiler operation-
theg mag become hot.
_, Handles of pots and pans on the cooktop
may become hot if left too close to the vent.
Do not leave plastic or flammable items on
the cooktop-they may melt or ignite if left
too close to the vent.
Do not leave closed containers on the
cooktop. The pressure in dosed containers
mag increase,which mag cause them to
burst.
_, Meta! items wil! become verg hot if theg are
left on the cooktop, and could cause burns.
Power Outuge
^,,,, CAUTION:oonot make any
attempt to operate the electric ignition oven
during on electrica! power failure.
The oven or broiler cannot be lit during a
power failure. Gas will not flow unlessthe
glow bar is hot.
If the oven is in use when a power failure
occurs, the oven burner shuts off and cannot
be re-lit until power is restored.This is
because the flow of gas isautomaticallg
stopped and will not resume when power
is restored until the glow bar has reached
operating temperature.
Oven Light
Touch the Oven Light pad on the upper
control panel to turn the light on or off.
14