Fedders 23-23-0259N-006 Installation & Operation Manual page 8

F PERATION -"}
ELECTRONIC CONTROLS
Electronic Control Panel
(_) Power Control
The Power Control turns the unit on and off.
@ Set Temperature/Timer Display
Shows the set temperature when the unit is in operation and hours when the timer is being
set. THE TEMPERATURE DISPLAY ONLY SHOWS THE SET TEMPERATURE, NOT THE
ACTUAL ROOM TEMPERATURE.
Q Temperature/Timer Hour Controls
These buttons are used to raise or lower the set temperature. By depressing both buttons at
once, the display will toggle between Celsius and Fahrenheit. When the timer is being set,
these buttons are used to change the hour setting in increments of I hour from 00 to 24.
@
Mode Control
A green light will indicate which mode is currently being utilized
Cool Mode - The unit will circulate and cool the air
Fan Mode - The unit will only circulate the air
Energy Saver Mode - The fan will switch from the set fan speed to LOW whenever the
compressor turns off in response to the thermostat. When the compressor cycles back on,
the unit will return to the original fan setting.
®
Fan Speed Control-
High, Low, and Auto @
The fan speed is adjusted with the Fan Speed Control, each time the button is depressed it
changes the setting. A green light will indicate which setting is currently being used.
Auto Feature -When the AUTO feature is selected while the air conditioner is in the
COOL mode, the fan speeds will change automatically as the temperature in the room
changes.
• High fan: If the room temperature is 4 ° or more above the set temperature.
• Low fan: If the room temperature is less than 4 • above the set temperature.
(_ Timer Control
The timer can be set to either turn the unit on or off. _ @
To turn the unit on using the Timer:
Depress the timer key when the power is off, the display will read 00. Adjust to the desired
number of hours before TURN ON using the up/down arrows.
The display will show the time by hours left until TURN ON.
To Turn the timer off, depress the timer key.
A green light next to the Timer Control indicates that the timer is set.
To turn the unit OFF using the Timer:
Depress the timer key when the power is on, the display will read 00. Adjust to the desired
number of hours before TURN OFF using the up/down arrows. The display will
automatically go back to the set temperature after 10 seconds.
To display the amount of time left until TURN OFF, depress the timer button once.
To turn the TIMER OFF, depress the timer button twice.
A green light next to the Timer Control indicates that the timer is set.
!2 Oo
® COOL e FAN
@
ONIO_
®
Power Control
Temperature/Timer Display
_ emperature/Timer Controls
Mode Control
0 Fan Speed Control
0 Timer On/Off
Built-in three minute timing delay.
This electronic controlled unit will
not automatically resume operation
after a power failure.
ff this electronic unit will not respond
to touch pad or remote control
commands, it is necessary to unplug
the unit from the electrical outlet for
five seconds and then plug the unit
back in.
Air Conditioner Remote Control
The functions work the same as your air conditioner's touch controls.
o
CAUTION:
• Use only AAA or IEC R03 1.5V batteries.
• Remove the batteries if the remote controller is not used for a
month or longer.
• Do not attempt to recharge the supplied batteries
• All batteries should be replaced at the same time.
• Do not dispose of the batteries in a fire as they may explode.
• Do not mix old and new batteries.
• Do not install the batteries with the polarity (+/-) reversed.
• Keep batteries and other things that could be swallowed away
from young children. Contact a doctor immediately if an object
is swallowed.
• Do not mix alkaline, standard (carbon- zinc), or rechargeable
(nickle-cadmium) batteries.
8