Fedders 23-23-0259N-006 Installation & Operation Manual page 3

Installation Parts
® © © ®
© @
Tools Needed
t)
® Blade-type screwdriver ® Knife
O Hammer (_ Hex driver, ratchet or
(_ Rule or tape measure wrench
(_ Level
C) Cabinet
(_ Sliders
C) Filler panel
Side Seal
(_ Sill bracket
® Support bracket
(_ Foam
Fasteners:
®Hex head screw (6)
®1" long wood screw (6)
©5/8" long machine screw (2)
®Carriage bolt (2)
(_Flange nut (4)
(_)Upholsterer's tack (6)
Window Requirements 28 1/2" to 40" Wide
This air conditioner is factory prepared for installation ill standard
double-hung windows with actual opening width of 28 1/2" to 40"
and clear, vertical opening of 21" minimum from bottom of sash to
sill.
Note: Unit can be installed in a 27" wide window, if cabinet side seals
are not installed. Use foam seal to fill any openings between the sides of
the cabinet and the window stop molding.
Decorative Front Removal
Detach front panel from cabinet by removing attachment screws on
both sides of unit (Fig. 3).
Removing the Chassis
Remove the two (2) shipping screws from both sides of the cabinet.
Slide the chassis out of the cabinet by pulling the chassis forward
while bracing the cabinet (Fig. 4).
Caution:
Use two or more people to move and install air conditioner.
Failure to do so can result in injury.
Use caution when working around exposed sharp edges of the
cabinet and sharp coils to avoid injury or torn clothing.
M
[_) Decorative front (_ Shipping Screw
retaining screw
IBII
C)Cabinet (_ Chassis