Remote Control - Kenmore 580.74085 Owner's Manual

REMOTE CONTROL
NOTE: The Remote Control will not operate properly if strong light shines on the sensor window of the Air
Conditioner or if there are obstacles between the Remote Control and the Air Conditioner.
Every time you push button, you will hear a beep from the Air Conditioner.
POWER
• To turn the air conditioner ON, push this button.
To turn the air conditioner OFF, push the button again.
• This button takes priority over any other button.
• When you first turn it on, the unit is in cool mode, High fan speed,
Temperature setting at 72°F.
• Auto Restart
In the event at a power failure, the unit will run at the previous setting once
power returns.
TEMPERATURE SETTING
• Use this button to automaticallycontrol the temperatureof the room.
The temperaturecan be set within a range of 60°Fto 86°Fby
incrementsof I°F.
• The settingappearsin the display.
FAN SPEED
• Every time you pushthis buttonit advancesthe settingas follows:
(High -* Low -* Meal -* High)
TIMER
- SHUT-OFF TIME
• You will
usually
use shut-off time while you
sleep.
• If unit is
running,
use Timer to set number of hours until shut-off.
• For your
sleepingcomfort,
once Time is
set, the Temperaturesetting
will
raise 2°F after 30
min,
and once
again
after another 30 min.
• Push Timer button to advance
setting
from 1
Hour
-+
2Hours -+...
-+
12Hours maximum.
- STARTTIME
• If unit is off, Timersets numberof hours beforeunit starts.
• PushTimer button to advancesettingfrom 1Hour-+2Hours =, ... =*
12Hoursmaximum.
Power
• Temp •
Fan Speed
I Timer Mode
MODE
- Push this button to shift mode of operation from COOL -* ENERGY SAVER -* FAN.
- ENERGY SAVER:
• The fan stops when the compressor stops cooling. Approximately every 3 minutes the fan will be turned on so
that the unit can check the room air temperature to determine if cooling is needed.
-15-