Controlpanel - Kenmore 580.74085 Owner's Manual

CONTROLPANEL
_FAN SPEED
• Everytime you push this button,it advancesthe settingas follows: {High-* Low-* Med-* High}
Applied to 580.74085, 580.74124
(-TIMER
- SHUT-OFF TIME
• You will usually use shut-off time while you sleep.
• If unit is running, use Timer to set number of hours
until shut-off.
• For your sleeping comfort, once Time is set, the
Temperature setting will raise 2°F after 30 rain.,
and once again after another 30 min.
• Push Timer button to advance setting from 1Hour
-* 2Hours -* ... -_ 12Hours maximum.
- START TIME
• If unit is off, Timer sets number of hours before unit
starts.
• Push Timer button to advance setting from 1Hour
-, 2Hours -, ... -, 12Hours maximum.
REMOTE CONTROL SIGNAL
RECEIVER
TEMPERATURE SETTING
• Use this buttonto automaticallycontrolthe
temperatureof the room.
The temperaturecan be set within a range
of 60°Fto 86°F by incrementsof 1°F.
• The settingappearsin the display.
POWER
• To turn the air conditioner ON, push this
button.
To turn the air conditioner OFF, push the
button again.
• This button takes priority over any other
button.
• When you first turn it on, the unit is in
cool mode, High fan speed, Temperature
setting at 72°F.
- AUTO RESTART
• In the event at a power failure, the unit
will run at the previous setting once
power returns.
MODE
- Push this button to shift mode of operation from COOL -_ ENERGY SAVER -_ FAN.
- ENERGY SAVER:
• The fan stops when the compressor stops cooling. Approximately every 3 minutes the fan will be turned
on so that the unit can check the room air temperature to determine if cooling is needed.
-14-