Equipment - JVC RX-5030VBK Instructions Manual

By changing the transmission signals, you can use the remote
control supplied for this unit to operate other manufacturers'
equipment.
• Refer also to the manuals supplied for the other products.
• To operate these components with the remote control, first
you need to set the manufacturers' code each for TV, CATV
converter, VCR and DVD player.
• When replacing the batteries in the remote control, set the
manufacturers' codes again.
To change the transmission signals for
operating a 13/
! Set TV/CATV selector to "TV"
2 Press and hold STANDBY/ON O/I TV/CATV.
3 PressTV SOUND.
4 Enter manufacturer's codes using buttons
1 - 9, and O.
5 Release STANDBY/ON _/i TV/CATV.
Now, you can perform the following operations on the TV.
STANDBWON d_)/I TV/CATV
Turn on or off the TV.
TVNIDEO Set the input mode (either TV or
VIDEO).
TV VOLUME +/- Adjust the volume.
TV/CATV OH +/- Change the channels.
After pressing TV SOUND, you can perform the following
operations on the TV:
1 - 9, 0, +10 (100+) Select a channel.
ENTER (10) Function as the ENTER button.
Note:
Refer also to the manual supplied with your TV
6 Try to operate yourTV by pressing
STANDBY/ON _)/I TV/CATV.
When your TV turns on or off, you have entered the correct
codes.
If more than one code is listed for your brand of TV, try
each one until the correct one is entered.
Manufacturers' codes forTV
Manufacturer Codes
JVC 01
Hitachi 10
Magnavox 02
Mitsubishi 03
Panasonic 04, 11
RCA 05
Samsung 12
Sanyo 13
Sharp 06
Sony 07
Toshiba 08
Zenith 09
"01 "is the initial setting,
To change the transmission signals for
operating a CATV converter
! SetTV/CATV selector to "CATV."
2 Press and hold STANDBY/ON _/i TV/CATV.
3 PressTV SOUND.
4 Enter manufacturer's codes using buttons
1 - 9, and 0.
5 Release STANDBY/ON 0/i TV/CATV.
Now, you can performthe following operations on the
CATV converter.
STANDBY/ON Oil TV/CATV
Turnon or off the CATV converter.
TV/CATV OH +/- Change the channels.
6
After pressing TV SOUND, you can perform the following
operations on the CATV converter:
1 - 9, 0, +10 (100+) Select the channels.
ENTER (10) Function as the ENTER button.
Note:
Refer also to the manual supplied with your CATV converte_
Try to operate your CATV converter by
pressing STANDBY/ON _b/iTV/CATV.
When your CATV converter turns on or off, you have
entered the correct codes.
If more than one code is listed for your brand of CATV
converter, try each one until the correct one is entered.
Manufacturers' codes for CATV converter
Manufacturer Codes
Echostar 01
General Instrument 02, 03, 04, 05,
06, 07, 08, 09
Hamlin 16, 17, 18, 19
Pioneer 14, 15
RCA 20
Scient 10, 11
Sony 21
Zenith 12, 13
"01" is the initial setting.
Manufacturers' codes are subject to change
without notice, If they are changed, this remote
control cannot operate the equipment.
36