JVC RX-5030VBK Instructions Manual page 62

Sound Adjustments
F_ Remote control
INPUT ATT ADJUST
o
o
i i
SUBWOOFER
OUT ON/OFF
EXIT
MULTI JOG
dial
0000
0000
0000
dVC
aEraTE CONTaO_
m_
RX-6030V
RX-6032V
ONLY
BASSBOOST
When the input level of the analog source is too high, the
sound will be distorted. If this happens, you need to attenuate
the input signal level to prevent the distortion.
Once this has been adjusted, this receiver memorizes the
adjustment for each source.
Press and hold INPUT ATT on the front panel so that the
INPUT ATT indicator lights up on the display.
• Each time you press and hold the button, the Input
Attenuator mode turns on ("INPUT ATT ON") or off ("INPUT
NORMAL').
Note:
When selecting "DVD MULTI" (RX-603OVBK and RX-6032VSL only)
as the source, this effect does not work,
When the subwoofer is set to "YES" (see page 15), you can
choose to turn off subwoofer output.
Press SUBWOOFER OUT ON/OFF on the front panel to
turn off the subwoofer.
"SUBWOOFER OFF" appears on the display for a while and
the _ indicator goes off.
5U I,4DDFER DFF
The subwoofer sound comes out of the front speakers.
To turn on the subwoofer, press the button again.
Notes:
• This button does not work when the subwoofer is set to "NO" (see
page 15). In this case, "NO SUBWOOFER" will appear on the
display for a while.
• You cannot turn off subwoofer output when the front speaker size is
set to "SMALL."
• When you change the subwoofer setting from "NO" to "YES,"
subwoofer output is automatically turned on.
You can boost the bass level.
Once you have adjusted the bass boost level, this receiver
memorizes the adjustment for each source.
Press BASSBOOST on the remote control to select the
bass boost function.
• Each time you press the button, the bass boost function
turns on and off.
BASSBOOST ON Select this to activate the bass boost
function.
The BASS BOOST indicator lights up on
the display.
BASSBOOST OFF Select this to cancel it.
The BASS BOOST indicator goes off.
Note:
This function affects the front speakers sound only.
18