JVC RX-5030VBK Instructions Manual page 12

Digital Connections
This receiver is equipped with two DIGITAL IN terminals_ne
digital coaxial terminal and one digital optical terminal.
You can connect any component to one of the digital terminals
using a digital coaxial cable (not supplied) or digital optical
cable (not supplied).
Digital coaxial cable
Before plugging the power cord into an AC outlet, make sure
that all connections have been made.
Plug the power cord into an AC outlet.
Keep the power cord away from the connecting cables and the
antenna. The power cord may cause noise or screen
interference. We recommend that you use a coaxial cable to
connect the antenna, since it is well-shielded against
interference.
CAUTIONS:
• Do not touch the power cord with wet hands.
• De net pull on the power cord to unplug the cord. When unplugging
the cord, always grasp the plug so as net to damage the cord.
Digital optical cable
IM PORTANT:
• When connecting a video component using the digital terminal, you
also need to connect it to the video jack on the rear. Without
connecting it to the video jack, you cannot view the playback picture.
• After connecting the components using the DIGITAL IN terminals,
correctly set the following if necessary:
-Set the digital input (DIGITAL IN) terminal setting correctly. For
details, see "Selecting the Digital Input Terminals--DIGiTAL IN" on
page 16.
-Select the digital input mode correctly. For details, see "Selecting
the Analog or Digital Input Mode" on page 17.
When the component has a digital
coaxial output terminal, connect it to the_
DIGITAL 1 (DVD) terminal, using the _ I
digital coaxial cable (not supplied). _ I SiGITAL 1
When the component has a digital _o_fa_t
optical output terminal, connect it to the _
/
DIGITAL 2 (CD) terminal, using the [_, I SlGITAL2(CO)
digital optical cable (not supplied). _
_ L_DIGITAL _
Before connecting a
digital optica, cab,e, _
unplug the protective
plug.
Notes:
• When shipped from the factory, the DIGITAL IN terminals have been
set for use with the following components:
-DIGITAL 1 (coaxial): For DVD player
-DIGITAL 2 (optical): For CD player
• When you want to operate the CD player or CD recorder using the
COMPU LINK remote control system, connect the target component
also as described in "Analog connections" (see page 7).
• When you want to operate the DVD player using the AV COMPU
LINK remote control system, connect the DVD player also as
described in '_Analog connections" (see page 9).
Before using the remote control, put in two the supplied
batteries first.
• When using the remote control, aim the remote control
directly at the remote sensor on the front panel.
l! On the back of the remote F_--_i---_
control, remove the _
battery cover.
2 Insert batteries.
• Make sure to match the polarity:
(+) to (+) and (-) to (-).
3 Replace the cover.
If the range or effectiveness of the remote control decreases,
replace the batteries. Use two R6P(SUM-3)/AA(15F) type dry-
cell batteries.
CAUTION:
Follow these precautions to avoid leaking or cracking cells:
• Place batteries in the remote control so they match the polarity:
(+) to (+) and (-) to (-).
• Use the correct type of batteries. Batteries that look similar may
differ in voltage.
• Always replace both batteries at the same time.
• De net expose batteries to heat or flame.
10