JVC RX-5030VBK Instructions Manual page 76

Operating JVC's Audio/Video Components
You can use the remote control to operate other JVC
components.
.[._ IF_'Tr_,/t"_ . ,PIITI = TaTtzm _
IM PORTANT:
To operate JVC's audio components using this remote control:
• You need to connect JVC's audio components through the COMPU
LINK-4 (SYNCHRO) jacks (see page 29) in addition to the
connections using cables with RCA pin plugs (see page 7).
• Aim the remote control directly at the remote sensor on the receiver.
• If you use the buttons on the front panel, the remote control will not
operate that source. To operate a source with the remote control, the
source must be selected using source selection buttons on the
remote control.
• To operate the cassette deck or CD recorder using the COMPU
LINK remote control system, set the source name correctly. (See
page 12.)
• Refer also to the manuals supplied with your audio components.
JVC JVC
Sound Adiustment
You can always use the following buttons:
SURROUND Turn on and select the Surround
modes.
DSP Turn on and select the DSP modes.
SURROUND/DSP OFF Turn off the Surround or DSP
modes.
After pressing SOUND, you can use the following buttons for
the sound adjustment:
SUBWFR -* LEVEL +/- Adjust the subwoofer output level.
FRONT L -* LEVEL +/- Adjust the left front speaker
output level.
FRONT R -* LEVEL +/- Adjust the right front speaker
output level.
CENTER -* LEVEL+l- Adjust the center speaker output
level.
SURR L -* LEVEL+l- Adjust the left surround speaker
output level.
SURR R -* LEVEL+l- Adjust the right surround speaker
output level.
TEST Turn on or off the test tone
output.
Note:
When you use the 10 keys to operate your target source after sound
adjustments, press the source selection button first so that the 10
keys work for the target source.
32