Summary of Contents for LIFESTYLER EXPANSE 1000 831.297451
Page 1
Decal _kCAUTION!: Read all safety precautions and instructions in this manual before using this equipment. Keep this manual in a safe place for future reference. 0-10MPH _ 2.0HP_ PROGRAMMABLE OWNER'S MANUAL SEARS, ROEBUCK AND CO., HOFFMAN SPEED/INCLINE ESTATES, IL 60179...
Page 2
For 90 days from the date of purchase, when proper assembly and maintenance procedures detailed in the Owner's Manual are followed, SEARS will, free of charge, repair or replace and install a replacement part for any defective part, when this treadmill is used in a normal manner.
This is especially important for persons over the age of 35 or persons with pre-existing Read all Instructions before using. SEARS assumes no responsibility for personal injury or property dam- age sustained by or through the use of this product.
6. Never start the treadmill while you are standing on the walking belt. Always hold the handrail when exercising on the treadmill. 7. Never allow more than one person on the treadmill at a time. The treadmill should not be used by per- sons weighing more than 250 pounds.
6 p.m. Mountain Time (excluding holidays). To help us assist you, please note the product model num- ber and serial number before calling. The model number of the treadmill is 831.297451. The serial number can be found on a decal attached to the treadmill (see the front cover of this manual for the !ocation).
ASSEMBLY Complete the assembly steps withthe help of a second person. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed. THE FOLLOWING TOOLS ARE REQUIRED FOR ASSEMBLY: The 7/32" allen wrench...
Grounded Outlet Box Grounding Grounding Grounded Outlet MAINTENANCE-FREE WALKING Your treadmill features a maintenance-free other substances to the walking belt and cause excessive wear. outlet that is properly installed and grounded...
Page 8
=on" position. Plug in the power cord (see PLUGGING IN THE POWER CORD on page 7.) Step onto the foot rails of the treadmill. Locate the clip attached to the safety key, and slide the clip onto the waistband of your clothing.
Page 9
(If the treadmill is run for longer than 99 minutes and 59 seconds, the display will reset to zero and the treadmill will slow to a stop.) If desired, a time goal can be set. To set a time goal, first make sure that the walking belt is stopped.
Page 10
SPEED display--This display shows the current speed of the walking belt. PULSE display--This display shows your heart rate. To use the pulse display, first stand on the foot rails and place your thumb on the pulse sensor as shown. The pulse sensor is pressure-activated. down the sensor.
2. SYMPTOM: THE POWER TURNS OFF DURING USE a. Check the circuit breaker located on the treadmill near the power cord. tf the circuit breaker has tripped (see the drawing above.), wait for five minutes and then press the switch back in.
Page 12
6. SYMPTOM: THERE IS A NOTICEABLE DIFFERENCE IN THE INCLINE RANGE OF THE TREADMILL a. Raise the incline of the treadmill to its maximum height and continue to press the incline button for three seconds. This will recalibrate the incline system.
CONDITIONING GUIDELINES The following guidelines will help you to plan your exercise program. Remember that proper nutrition and ade- quate rest are essential for successful results. , WAR NIN G: Before beginning especially important for individuals over the age of 35 or individuals with pre-existing EXERCISE INTENSITY To maximize the benefits of exercising, it is important to exercise with the proper intensity.
TREADMILL. All parts listed herein can be ordered through SEARS, ROEBUCK AND CO. SERVICE CENTERS and most SEARS RETAIL STORES. If parts you need are not stocked locally, your order will be transmitted to a SEARS PARTS DISTRIBUTION CENTER for handling.