Maintenance And Troubleshooting; Operating Instructions; Incline Adjustment; Walking Belt Adjustment - LIFESTYLER Inckine Lift assist 1900 Owner's Manual

OPERATING
INSTRUCTIONS
.
2.
Step onto the foot rails and hold the side rails with a firm grip.
Attach the clip on the safety key to the waistband of your clothing. Insert the key into the power
switch. To turn the power on, move the key to the right. IMPORTANT: For your safety, always
wear the clip when using the treadmill. If you slip or fall while exercising, the key will be
disengaged from the switch, instantly turning the power off.
3. Turn the speed control knob counterclockwise until it stops at the "Reset" position, and then
clockwise until the walking belt begins to move. Note: The speed control knob must first be
turned to the "Reset" position each time the power is turned on.
4. Carefully step onto the moving walking belt and begin walking.
.
Slowly turn the speed control knob until the desired speed is reached. Turn the knob clockwise to
increase the speed, or counterclockwise to decrease the speed.
6. To turn the treadmill power off, move the safety key to the left. Remove the key fromthe switch.
INCLINE ADJUSTMENT
.
2.
o
TURN THE POWER OFF. Remove the hitch pins from the
left and right front legs. Note: The hitch pins have been
inserted from the inside for shipping purposes.
Grasp the lock knob, and raise or lower the treadmill to the
desired height.
Insert the hitch pins through the front legs from the outside
as shown. The pins must be in the same holes in both legs
ELECTRONIC MONITOR OPERATION
f
Hitch Piny
._ _Lock Kno_
See the ELECTRONIC MONITOR OPERATION GUIDE accompanying this manual. A 9-volt battery
must be installed in the electronic monitor before the monitor can be operated.
MAINTENANCE AND TROUBLE-SHOOTING
This treadmill is designed to be virtually maintenance-free. Outside surfaces of the treadmill can be
cleaned using a damp cloth and mild, non-abrasive detergent. Do not allow liquids to come in contact
with the console.
WALKING BELT ADJUSTMENT
The walking belt should always be kept centered on the walking platform. If the belt shifts to the right
or left sides of the platform, the belt may be damaged by the roller guard screws. The belt can be
adjusted using the rear roller adjustment bolts and the allen wrench included. CAUTION: ALWAYS
TURN THE POWER OFF BEFORE ADJUSTING THE WALKING BELT.