Roller Guard Adjustment; Circuit Breaker; If The Walking Belt Has Shifted To The Left; If The Walking Belt Has Shifted To The Right - LIFESTYLER Inckine Lift assist 1900 Owner's Manual

IF THEWALKINGBELTHASSHIFTEDTO THELEFT:
TURNTHE POWEROFF. Turn the leftadjustmentbolt
clockwise,andthe right adjustmentboltcounterclockwise,
1/4 of a turn each. Turn the poweron. Repeatas
necessaryuntilthe belt is centered.
IF THE WALKINGBELTHASSHIFTEDTO THE RIGHT:
TURNTHE POWEROFF.Turn the leftadjustment b olt
counterclockwise, a ndthe rightadjustmentbolt clockwise,
1/4 of a turn each. Turnthe poweron. Repeatas
. necessary until the belt iS centered.
IF THE WALKING BELT SLIPS DURING USE: TURN THE
POWER OFF. Turn both adjustment bolts clockwise 1/4 of
a turn. Turn the power on. Repeat as necessary until the
belt does not slip. Be careful not to overtighten the bolts.
Overtightening can stretch the belt, cause excessive roller
noise, and reduce motor performance.
To check the walking belt for proper tension, TURN THE
POWER OFF, and lift the edges of the walking belt. You
should be able to lift each edge 2-3 inches off the walking
platform. The center of the belt should remain just at the
surface of the platform.
The allen wrench can be stored conveniently on the self-
adhesive wrench clip.
ROLLER GUARD A[)JUSTMENT
The rear edge of the roller guards should be 1/8 inch from
touching the rear roller. To adjust the roller guards, loosen
the screws in the roller guards, slide the roller guards
forward or backward, and retighten the screws.
CIRCUIT BREAKER
If the treadmill stops, or will not start, check the circuit
breaker located on the front of the frame, The circuit
breaker is designed to protect the electrical system. If the
circuit breaker has tripped, the switch will protrude as
shown. To reset the circuit breaker, allow the treadmill to
cool for a few minutes, MOVE THE SAFETY KEY TO THE
OFF POSITION and push the switch back in.
RoerB
Wrench Clip
Roller Guard_
Rear Roller
i m
J
)
Tripped
Reset