Hoover U5473-900 Owner's Manual page 8

TRANSPORTINGCLEANER
To move your cleaner
from room to room,
put handle in upright
position, tilt cleaner
back on rear wheels
and push forward.
CARRYHANDLE
The cleaner can also be
moved by using the
carry handle.
HANDLEPOSITIONS
The handle of your
cleaner has three
positions; upright for
Storage and when
using cleaning tools;
operating position for
general operation on
carpet and floors; low
for reaching under low
furniture. Step on
handle release lever
to lower handle.
EMBEDDED DIRTFINDER
TM
(Available on select models only)
With red and green lights
(A), the 'DirtFINDER'
system alerts the user to
areas of carpet that may
need more cleaning
attention, It is able to
sense when larger
amounts of dirt particles,
especially embedded dirt,
are removed,
To let you know that the
DidFINDER
TM
feature is ready, the red light will
come on when the cleaner is first turned on, After a
few seconds, the red light will go off and the green
light will come on. Cleaning may then begin,
The green light will remain on throughout cleaning
except when the detector senses that a larger
amount of dirt is being picked up; then the red light
will come on.
When the red light is on, you should fake additional
cleaning strokes in the area until it changes to
green,
* The red light may seldom come on dudng
cleaning. This means that your cleaner is picking up
primarily fine surface dust and lint which the system
may not detect, or that the carpet is generally clean.
TO increase the feature's sensitivity to dirt, set the
switch (B) to the "Hi" position.
. At other times, the red light may stay on for a
considerable amount of time. This means that the
carpet contains a high level of dirt which is being
removed by the cleaner. To decrease the feature's
sensitivity to dirt, set the switch to the "Reg"
(Regular) position.
CARPETHEIGHTADJUSTMENT
The cleaning of carpet
and rugs takes place
at the nozzle (A),
When it is necessary
to raise and lower the
nozzle for various
carpet pile heights,
slide the nozzle
control knob (B) to the
desired setting.
HANDLEPOSITION
1e se in s "d'n
knob, the handle should
be in the updght
position (C). C
The nozzle will not
move into the adjusted
position until the
cleaner handle is
lowered to the operating
position (O).
8