Related Manuals for Hoover WindTunnel U5471-900
Summary of Contents for Hoover WindTunnel U5471-900
- Page 1 WindTunnel by HOOVER Congratulations on your purchase! This WindTunnel vacuum cleaner uses HOOVER® HEPA Filtration Type "Y" filter bags This product designed easy assembly (See page www.hoover.com...
-
Page 2: Table Of Contents
Hoover Factory Service Center or Authorized Hoover Warranty Service Dealer (Depot). • Use vacuum cleaner only for its intended use as described in the instructions. Use only attachments recommended by The Hoover Company; others may cause hazards. Save these... -
Page 3: Assembling Cleaner
This cleaner was inspected and packaged carefully before being shipped from the factory. If you should happen to need assistance during assembly or operation, Visit us online at www.hoover.com to find the service outlet nearest you (click on the "Service" button) OR Call 1-800-944-9200 for an automated referral of authorized service outlet locations (U.S. - Page 4 Push bolts into holes on back of Remove bag door on cleaner body While holding rack in place, slide handle. by pushing down at top of door and handle onto cleaner body. pulling door outward. Make sure tab is inserted fully into slot.
-
Page 5: Cleaner Descriptions
iEl_! [nfnnl[,'l Insert ends of dusting brush (A), Remove switch lock (A) above ON/ OFF switch (B) by pulling it straight crevice tool (B) into storage areas. out. Dispose of switch lock. Place smaller unridged end of wand Secure furniture nozzle (C)in clip. If switch lock has come off during into bottom of rack. -
Page 6: Embedded Dirtfinder
Transporting cleaner Carrying cleaner Handle positions The cleaner can also be moved by The handle of your cleaner has three To move your cleaner from room to using the carrying handle. positions; upright for storage and room, put handle in upright position, when using cleaning tools;... -
Page 7: Cleaning Tools
Edge cleaning Stair cleaning Cleaning lightweight flexible rugs A stair cleaning handle has been Special edge groomers are provid- designed for ease in usingyour ed on both sides of the nozzle to Stand on one end of rug and move cleaner on stairs. - Page 8 It is imperative that you use only not show red. blockages" section). genuine HOOVER filter bags distrib- uted by The Hoover Company to CAUTION: Very fine materials, assure that your cleaner operates at such as face powder or corn- peak performance.
-
Page 9: Cleaning Filters
Should you want to replace this fil- mild detergent, then air dry. you clean the filters. ter, ask for HOOVER part No. Removing debris under the shield Reposition dry filter and grill. 40110004. will help maintain your cleaner's... -
Page 10: Replacing Belt
Headlight replacement What to buy This cleaner uses a 12 volt, wedge base type 912 bulb, Hoover part No. 27313101. Installing bulb Replacing lens Removing lens Pull old bulb straight out of socket. Reposition lens and secure with the Disconnect cleaner from electrical two screws. -
Page 11: Lubrication
Fig. 3- lowing: 13" - HOOVER part No. 48414110 Discard old agitator. 15" - HOOVER part No. 48414115 Continue following the directions in "The belt" section to reposition belt, new agitator and bottom plate. -
Page 12: If You Have A Problem
U.S.A., phone 1-800-944-9200 3) Look into (C) and remove blockage. Possible Cause visit The Hoover Company on=line at Possible Solution 3. Check connection at hose tube www hoover corn • Broken or worn belt (B); remove any blockage.