Belt - Hoover U5473-900 Owner's Manual

Check AgitatorShield
Because your cleaner picks Up so well, v,_ strongly recommend you check for debris accumulation under the
agitator shield each time you dean _he riflers.
Removing debris under the shield will help maintain your cleaners excellent pick up and suction. Remove
debris as follows:
1, Disconnect cleaner from electrical outlet.
2. Check for dirt accumulation by removing bottom plate (Fig. 4-10), removing agitator (Fig. 4-11), and lifting
agitator shield (Fig. 4-13).
3. Remove any debffs and replace shield, agitator and bottom plate (Figs. 4-13 to 4-15).
-IEADLIGHT:
H owto Replace
Available on select models on[y)
A WARNING A
To reduce the risk of electric shock, unplug
vacuum before cleaning or servicing.
Removing Lens
4.7 Using a screwdriver, remove the two screws as
shown and lift off lens.
InstallingBulb
4.8 Puff old bulb straight out of socket. Push new
bulb straight into socket until Locked in place.
Excessive force Jsnot required.
ReplacingLens
4.9 Reposition lens and secure with the two screws.
BELT:How to
Replace
The belt on your HooveP cleaner causes the agitator
to rotate and is important for the effective operation of
the cleaner. The belt is located under the bottom
plate of the cleaner and should be checked from time
to time to be sure it is in good condition.
,& CAUTION A
To reduce the dsk of injury from moving parts,
unplug vacuum before servicing.
Whento Replace
To check belt, remove bottom plate as shown in
"How to replace". Replace belt if it is stretched, cut
or broken.
Howto Replace
P_ace handle in tow position and turn c_eaner over
so bottom side is up.
4.10 Remove the 4 screws aS shown with a Phillips
screwdriver.
Lift off bottom plate (A),
4,11 Remove agitator brushralI and used bell
Discard used belt.
_3