GE JKP18 Owner's Manual page 12

Usingthe clock and timer.
Make sure the clock is set to the
correct time of da_
ToSet the Clock
Tile clock must be set to tile cone( t time
of day for tile autoinafic
oven
tiI'lting
tractions to work properly. Tile time of
day cannot be changed during a tilned
baking or self-cleaning o_cle.
[]
Press tile CLOCK pad.
[] Press tile number pads.
[] Press tlle START pad.
KITCHEN_ []
TIME
Ttie t#ner is a mflTutet#ner onl_
Ttie timer does not control oven
operations. Ttie maximum setting on
ttie timer is 9 hours and 59 mhTutes.
To Set the Timer
[]
[]
Press tile KITCHEN TIMERON/OFF
pad.
Press tile number pads until tile
atllotln[ of tiiile VOtl wan[ shows ill
tile displ W. For example, to set 2
hours and 45 minutes, press 2, 4 and
5 in that order. Ify{)u make a mistake
press tile KITCHEN TIMERON/OFF
pad and begin again.
Press tile STARTpad.
When tile timer reaches :00,
tile control will beep 3 times
folh)wed by one beep eveU 6
seconds until tile KITCHEN TIMER
ON/OFF pad is pressed.
Tile 6 second tone can be canceled by
fi)llowing tile steps in tile Special features
of your oven control section under Tones at
the End of a Timed Cycle.
NOTE: Onsomemodelsthetimecountsdown
/?nmedlate/y whentheSTART pad ispressedThe
tYnerisactuallycounting downin seconds that
arenotshownon thedisplay until thelastminute.
To Reset the Timer
If the display is still showing tile time
remaining, you may change it by pressing
the KITCHEN TIMER
ON/OFF
pad, then
press the number pads until the time you
want appears in the display.
If tile remaining time is not in tile display
(clock, delay start or cooking time are in
the display), recall the remaining time by
pressing the KITCHENTIMER
ON/OFF
pad
and then pressing the number pads/o
enter tile new time you want.
ToCancel the Timer
Presstile KITCHENTIMERON/OFF
pad t_d(e.
12