Remove Freezer Door; Remove Refrigerator Door - GE GTS18JCPXRBB Owner's Manual And Installation Instructions

Installation instructions
[_ REMOVE FREEZER DOOR
Tape the door shut with masking tape.
!
Remove the binge cover on top of the fleezer door
(on some models).
Remove the t_,voTorx ® screws, then lift the binge
suaight up to flee the binge pin flom the socket in
the top of the door
Remove the tape and tilt the door away flom the
cabinet. Lily it off the center binge pin.
Set the door on a non-scratching smface with
the inside up.
REMOVE REFRIGERATOR DOOR
Tape the door shut with masking rope.
Remove the center binge pin with a 3/8" socket
and ratchet.
I
Plastic Washer
HingePinZ _;t
Center Hinge _
Bracket
Fresh FoodDoor
Remove fl_e tape and tilt the door away flom fl_e
cabinet. Remove and save fl_e washer on fl_e binge pin.
Lif_ fl_e door smdght up to flee its bottom socket flom
the pin in the bottom binge bracket.
Set the door on a non-scratching smface with the
inside up.
CAUTION: Do not let door drop to the floor.
To do st) could damage the door stop.
TRANSFER TOP HINGE TO
THE LEFT
Interchange
binge and screws at top fight wifl_ screws
at the top lef_ of cabinet.
Do not tighten screws on hinge side at this time.
[_ TRANSFER BOTTOM HINGE
BRACKET TO THE LEFT
For models with a base grille, remove it by gnasping it
about 6" flom each end and pulling its bottom edge
toward you.
Using a Torx ®ohire,; move the bottom binge bracket
and plastic washer flom the fight side to the lef_ side.
NOTE: If the washe, is not on the binge b,acket,
check to see if it is stuck to the bottom of the door
PlasticWasher
Hing,
For models with a base grille, before replacing the
base grille, remove the grille cap by removing the
screw. Screw the cap to the opposite side.
Replace the base _ille by inse,ting d_e tops of d_e
metal clips into the oval vents, making sure one of the
plastic tabs on the back of the gqille goes into each of
the oven vents. Then push the bottom of the grille
fbrward until it snaps into place.
15