Operating Your Refrigerator; Freezer Door; Lcemaker; Temperature Control - GE TAX6 Use And Care Manual

OPERATING YOUR REFRIGERATOR

Starting
1. Clean the inside of the refrigerator with a mild
solution of baking soda and water (refer to the Care
and cleaning section).
2. Plug in the refrigerator.

Freezer Door

The inside freezer door separates the freezer section from the refrigerator
section, maintaining the correct temperature in each. The door has a spring
loaded, magnetic catch. To open, push gently. The latch will click and the
door will open. To close, push gently until the latch clicks.
OPERATING YOUR ICEIMAKER

How it Works

Water
adjustment
screw
behind cover
on side of
housing
Cover (pull
If your refrigerator is
connection is made, make sure the icemaker feeler
arm is in the STOP (up) position. When the water
supply has been connected to the icemaker, move the
icemaker feeler arm to the ON (down) position.
The ice cube mold will automatically fill with water
after cooling to a freezing temperature, and first cubes
will normally freeze after several hours. When cubes
are solidly frozen, they will be ejected from the mold
into the ice cube storage bin by means of a sweeper arm.
4

OPERATING YOUR FREEZER

icemaker will
operate
before the water
Temperature ControI
The temperature control dial is
located in the grille below the outer
door. A higher number setting
provides a cooler temperature.
Initially set the temperature control
dial at "3".
five minutes before restarting. This allows the motor
control time to automatically reset.
After waiting two hours, adjust the temperature
control to the setting that is best suited to your needs.
NOTE: Turning the temperature control dial to
"O" stops cooling but does not shut off power to
the refrigerator.
the bin is full.
For maximum ice storage, level the stored cubes with
your hand occasionally. Be sure nothing interferes
with the swing of the feeler arm.
We suggest you stir ice in the bin at least once a week.
If you do not do this, the cubes may clump together,
how much humidity is in the room.

Water Fill Adjustment Screw

There is a water-fill adjustment screw on the right
side of the icemaker behind the white front cover.
This allows adjustments for different water pressures.
To remove the cover, pull it forward. Turn the screw
clockwise to increase fill or counterclockwise to
decrease fill. Don't turn it more than one full turn or
the control can be damaged.
\*\\