Step 9 Adjust Door Swing; Step 10. Remove Door Trim - GE Monogram ZIRS360NNLH Installation Instructions Manual

STEP 9 ADJUST DOOR SWING

NOTE: This appliance has a 3-position door stop. When
space does not allow the door to swing open fully to
115°, you may change the door swing to a 90° opening.
A 130° door swing is available for standard installation
only. Skip this step if door opening is satisfactory for
your installation situation.
Pin Location
for 90°
Door Swing
• Open the door to view the bottom hinge. Note the door
stop pin locations. The pin is factory-installed in the
115° position.
• Close the door. From below, use pliers to unscrew the
door stop and reinstall into the 90° position.
Installation Instructions
Pin Location
for 130°
Door Swing
Pin Location
as Shipped
for 115°
Door Swing
22
STEP 10 REMOVE DOOR TRIM - FLUSH
INSTALLATION ONLY
Use the supplied Torx wrench or T10 Torx head driver
to remove all exposed trim screws securing aluminum
trim to door. Save all trim and screws as they will be
replaced in a later step.
1. Remove 6 screws and trim from the hinge side of the
door.
2. Remove 4 trim screws on vertical handle side of the
door to release handle cover trim. Remove the handle
cover trim to expose handle visor trim underneath.
3 Remove 4 additional trim screws from handle visor
trim. Once screws have been removed, remove handle
visor trim.
Handle side
trim
Handle
visor trim
Hinge side
trim