Reversing The Door Swing - GE GTS18JCPXRBB Owner's Manual And Installation Instructions

Installation instructions
iNSTALLiNG THE WATER LiNE
(CONT.)
[-gqPLUG iN THE REFRIGERATOR
A_range the coil of tubing so that it does not vib_ate
against the back of the lefligelatol ol against the
wall. Push the ,efiige,ato, back to the wall.
START THE ICEMAKER
On power switch models, set the icemakm power
switch to the ! (on) position.
On feeler a_m models,
move the feele, a,m to the ON (down) position.
The icemakm will not begin to opmate until it
,eaches its ope,adng tempemm,e of 15°F (-9°C) o,
below. It will then begin ope,afion automatically.
/
,,Y
,5'
Feeler Arm in the
STOP (up) position
Feeler A rm in
the OR (down)position
NOTE: In lowe, water plessule conditions, the
water
valve may
ttll'll Oil tip to 3
times
to
delivm
enough water to the icemake,.
REVERSING THE DOOR SWING
iMPORTANT NOTES
When leve_sing the dool swing:
* Read the inst_uctions all the way th_ough befole
sm,ting.
* Handle pa,ts ca,efhlly to avoid sc,atching paint.
* Set sclews down by their lelated pa_ts to avoid using
them in the wlong places.
* P,ovide a non-sc,atching wo,k smf_me fb,
the doo,s.
IMPORTANT: Once you begin, do not move the
cabinet until doo,-swing ,evmsal is completed.
These inst_uctions a,e fb, changing the binges fiom
the ,ight side to the left side--if you eve, want to change
the binges back to the ,ight side, follow these same
inst_uctions and leve,se all lefe.,ences to left and right.
Unplug the refrigerator from its electrical outlet.
Empty all door shelves, including the dairy
compartment.
TOOLS YOU WiLL NEED
Phillipsscrewdriver
Masking tape
T20or T25Torx ce
driver,whicheveryour
modelrequires
3/8" Headsocket driver
(a 6-pointsocket is
recommended)
Puttyknife or
thin-bladescrewdriver
14