Yamaha YZ450F Owner's Service Manual page 153

2. Install:
• Brake caliper "1"
• Bolt (brake caliper) "2"
Bolt (brake caliper):
28 Nm (2.8 m•kg, 20
ft•lb)
3. Tighten:
• Pad pin "3"
Pad pin:
18 Nm (1.8 m•kg, 13
ft•lb)
4. Install:
• Pad pin plug "4"
Pad pin plug:
2 Nm (0.2 m•kg, 1.4
ft•lb)
INSTALLING THE REAR BRAKE
CALIPER
1. Install:
• Pad support "1"
• Brake pad "2"
• Pad pin "3"
• Install the brake pads with their pro-
jections "a" into the brake caliper re-
cesses "b".
• Temporarily tighten the pad pin at
this point.
2. Install:
• Brake disc cover "1"
• Bolt (brake disc cover) "2"
Bolt (brake disc cover):
10 Nm (1.0 m•kg, 7.2
ft•lb)
FRONT BRAKE AND REAR BRAKE
3. Install:
• Brake caliper "1"
• Rear wheel "2"
Refer to "FRONT WHEEL AND
REAR WHEEL" section.
4. Tighten:
• Pad pin "3"
Pad pin:
18 Nm (1.8 m•kg, 13
ft•lb)
5. Install:
• Pad pin plug "4"
Pad pin plug:
2 Nm (0.2 m•kg, 1.4
ft•lb)
INSTALLING THE BRAKE
MASTER CYLINDER KIT
1. Clean:
• Brake master cylinder
• Brake master cylinder kit
Clean them with brake fluid.
2. Install:
• Brake master cylinder cup (prima-
ry) "1"
• Brake master cylinder cup (sec-
ondary) "2"
To brake master cylinder piston
"3".
Apply the brake fluid on the brake
master cylinder cup.
After installing, cylinder cup
should be installed as shown di-
rection. Wrong installation cause
improper brake performance.
5-12
3. Install:
• Spring "1"
To brake master cylinder piston
"2".
Install the spring at the smaller dia.
side.
4. Install:
• Brake master cylinder kit "1"
• Washer (front brake) "2"
• Push rod (rear brake) "2"
• Circlip "3"
• Brake master cylinder boot "4"
• Push rod (front brake) "5"
To brake master cylinder.
• Apply the brake fluid on the brake
master cylinder kit.
• Apply the silicone grease on the tip
of the push rod.
• When installing the circlip, use a
long nose circlip pliers.
A. Front
B. Rear