This sidestand "1" is used to support
only the machine when standing or
• Never apply additional force to
• Remove this sidestand before
This valve joint "1" prevents fuel from
flowing out and is installed to the fuel
tank breather hose.
In this installation, make sure the
arrow faces the fuel tank and also
SPARK PLUG WRENCH
This spark plug wrench "1" is used to
remove and install the spark plug.
This nipple wrench "1" is used to
tighten the spoke.
Install the handlebar protector "1" so
that the mark "a" face forward.
FUEL TANK HOLDING CABLE
The fuel tank holding cable "1" is
used to support the fuel tank during
FUEL HOSE JOINT COVER
The fuel hose joint covers "1" are
used to prevent mud, dust, and other
foreign material from entering the fuel
pump when the fuel hose is discon-
COUPLER FOR CONNECTING
This coupler "1" is used for connec-
tion to an optional Power Tuner and
When no optional parts, etc. are
connected, connect the connec-
tion terminal to the original cou-
Before removing the coupler, thor-
oughly wipe off any mud or water
stuck to it.
YZ Power Tuner
The YZ Power Tuner is optional.
PREPARATION FOR REMOVAL
1. Remove all dirt, mud, dust, and
foreign material before removal
• When washing the machine with
high pressured water, cover the
Silencer exhaust port
Drain hole on the cylinder head
Water pump housing hole at the
2. Use proper tools and cleaning
equipment. Refer to "SPECIAL
3. When disassembling the ma-
chine, keep mated parts together.
They include gears, cylinders,
pistons, and other mated parts
that have been "mated" through
normal wear. Mated parts must
be reused as an assembly or re-