Table of Contents
Advertisement
SW105 RECEIVER
BLACK SUPPLY
WIRE
WHITE RECEIVER WIRE
BLACK RECEIVER WIRE
BLACK/WHITE
RECEIVER WIRE
WHITE FAN WIRE
BLACK FAN WIRE
DOWNROD
Figure 16
WARNING
!
Check to see that all connections are tight, including
ground, and that no bare wire is visible at the wire
connectors, except for the ground wire. Do not
operate fan until blades are in place. Noise and fan
damage could result.
4. After connections have been made, separate the
white and green wires from the black, blue and
orange wires.
5. Carefully turn the wires upward and insert them up
through the open side of the hanger bracket and
into the outlet box. Push the green equipment/earth
ground and white grounded neutral wires into one
side of the outlet box; push the black, blue and
yellow ungrounded wires into the other side of the
outlet box.
HANGER
BRACKET
1-1/4" THREADED
STUDS (2)
Figure 17
6. Screw the two 1-1/4" threaded studs (supplied)
into the tapped holes in the hanger bracket (Figure
17).
WHITE SUPPLY WIRE
BLUE RECEIVER WIRE
BLUE FAN WIRE
YELLOW RECEIVER WIRE
YELLOW FAN WIRE
OUTLET BOX
RECEIVER
CEILING
COVER
7. Lift the ceiling cover up to the threaded studs and
turn until studs protrude through the holes in the
ceiling cover (Figure 18).
8. Secure the ceiling cover in place by installing two
lockwashers and two knurled knobs (supplied)
(Figure 18). Tighten the knurled knobs securely
until the ceiling cover fits snugly against the ceiling
and the hole in the ceiling cover is clear of the
downrod.
9. Your ceiling fan in now installed and wired.Proceed
to Switch Housing/Downlight Kit Installation to
complete your fan installation.
CEILING COVER
HANGER BALL/
DOWNROD ASSEMBLY
Figure 18
!
To avoid possible fire or shock, make sure that the
electrical wires are completely inside the outlet box and
not pinched between the ceiling cover and the ceiling.
Switch Housing Installation
NOTE: If no downlight is desired, continue with
switch housing installation.
NOTE: Do not install the downlight fitter assembly.
1. Attach the 9-pin connector of the switch housing to
the 9-pin connector of the fan assembly.
(Figure 19).
2. Place the switch housing onto the switch housing
plate aligning the three holes. Secure the switch
housing using three screws (supplied).
3. Screw the switch housing center plug into place.
SWITCH HOUSING
PLATE
SWITCH HOUSING
SCREW (3)
Figure 19
4. Your ceiling fan is now installed ready to be
controlled by your remove control system.
9
OUTLET
BOX
HANGER
BRACKET
1-1/4" THREADED
STUD (2)
LOCKWASHER (2)
KNURLED KNOB (2)
WARNING
FAN ASSEMBLY
9-PIN CONNECTOR
SWITCH HOUSING
9-PIN CONNECTOR
SWITCH
HOUSING
Advertisement
Table of Contents
