Table of Contents
Advertisement
NOTE: Take care not to scratch fan housing when
installing blades.
WARNING
!
To reduce the risk of personal injury, do not bend the
blade flange when installing the blade flanges,
balancing the blades or cleaning the fan. Do not
insert foreign objects in between rotating fan blades.
6. Loosely attach the flange assembly using two
1/4-20 x 16mm oval head screws (supplied)
(Figure 3). Install the remaining four fan blades
assemblies using the same procedure.
7. Gently snug all flange screws to the motor
housing, working around the housing in a
clockwise sequence. Failure to follow this
procedure could result in fan wobble. This
completes the blade installation.
8. Carefully turn the partially assembled fan/blade
assembly upright and rest the assembly onto the
styrofoam to continue the assembly.
9. Connect the fan motor housing yellow wire
single-pin connector to the black wire single-pin
connector from the uplight kit assembly; connect
the fan motor housing white wire single-pin
connector to the white wire single-pin connector
from the uplight kit assembly (Figure 4). Be sure all
wire connectors are fully engaged.
UPLIGHT KIT ASSEMBLY
WHITE WIRE SINGLE-PIN
CONNECTOR
FAN MOTOR HOUSING
WHITE WIRE SINGLE-PIN
CONNECTOR
Figure 4
CAUTION: Before installing and tightening the
screws, be sure there are no wires pinched
between the fan motor housing and the uplight kit
assembly.
10. Unscrew and save one of the three #8-32 x
10mm flat head screws in the fan motor housing.
(Figure 5).
11. Make sure all wires and single-pin connectors are
inside the uplight kit assembly, then position the
light kit assembly on the fan motor housing so
that the holes line up.
12. Rotate the uplight kit assembly clockwise to
engage the keyhole slots (Figure 5). Secure the
light kit assembly to the fan motor housing by
threading the previously removed screw into the
remaining hole. Tighten the three screws at this
time.
NOTE: Be sure wires and connectors are not
pinched under the uplight kit assembly before
securing the uplight kit assembly.
Figure 5
13. Install four 15-watt (maximum) candelabra light
14. Obtain the hanger ball/downrod assembly and
UPLIGHT KIT ASSEMBLY
BLACK WIRE SINGLE-PIN
CONNECTOR
FAN MOTOR HOUSING
YELLOW WIRE
SINGLE-PIN CONNECTOR
Figure 6
NOTE: The longer downrod (12") furnished with
the
recommended floor-to-fan blade clearance for a
9-foot ceiling. The 6" downrod (supplied) is to be
used for shorter ceilings.
15. Separate, untwist and unkink the black, white and
16. Slide the downrod down the wires and seat the
5
UPLIGHT KIT
ASSEMBLY
FAN MOTOR
HOUSING
bulbs (not supplied) in the uplight sockets
(Figure 5).
remove the hanger ball by loosening the
setscrew in the hanger ball until the ball falls
freely down the downrod (Figure 6). Remove the
pin from the downrod, then remove the hanger
ball. Retain the pin and hanger ball for
reinstallation in Step 25. Discard the 12" downrod
if using the 6" downrod.
PIN
HANGER
BALL
DOWNROD
ceiling
fan
provides
blue motor wires and the yellow uplight lead.
Route these wires through the downrod.
downrod in the motor coupling (Figure 7).
#8-32 x 10mm FLAT
HEAD SCREW (3)
KEYHOLE SLOT
UPPER GLASS
SHADE
15-WATT (max.)
CANDELABRA
LIGHT BULB (4)
SETSCREW
the
minimum
U.L. Model No.: CF820
Advertisement
Table of Contents
