READ AND SAVE THESE INSTRUCTIONS LA FAYETTE ™ Ceiling Fan Owner's Manual Model Numbers CF820ORB00 CF820PW00 Oil Rubbed Bronze Pewter 37.0 Net Weight: Lbs. Part No. F40BP73510000 Form No. BP7351 U.L. Model No.: CF820...
WARNING: To reduce the risk of fire or electric shock, this fan should only be used with fan speed control SW105, manufactured by Rhine Electric Co., Ltd. WARNING: To avoid fire, shock or injury, do not use an Emerson or any other brand of control not specifically approved for this fan.
Emerson Electric Co. could result in personal injury or property damage. 1. Open styrofoam unit containing fan. Remove upper and center sections of styrofoam unit. Remove parts and check to see that you have received the following: a.
1. Place the flange onto the blade. Secure the flange regulate your ceiling fan speed, airflow direction, to the blade using the four #10-32 x 8mm pan and light intensity. An optional Emerson Electric head screws and four #10 flat washers (supplied). SR110 Remote Control may also be used.
Page 5
NOTE: Take care not to scratch fan housing when NOTE: Be sure wires and connectors are not installing blades. pinched under the uplight kit assembly before securing the uplight kit assembly. WARNING To reduce the risk of personal injury, do not bend the #8-32 x 10mm FLAT blade flange when installing the blade flanges, UPLIGHT KIT...
Page 6
17. Loosen the two setscrews in motor coupling if IMPORTANT necessary. Separate, untwist and unkink the three 80” motor leads. Route the motor lead A. If you have installed the 12” or optional longer downrod and are planning to install the wires through the desired downrod.
25. Reinstall the hanger ball on the downrod WARNING as follows. Route the motor leads through the hanger ball and slide the hanger ball over the The outlet box and joist must be securely mounted downrod (Figure 11). Install the pin through the and capable of supporting at least 50 lbs.
How to Wire Your Ceiling Fan 3. Using wire connectors (supplied), make wiring If you feel that you do not have enough electrical connections as follows (Figure 15 and 16): wiring knowledge or experience, have your fan installed by a licensed electrician. a.
7. Lift the ceiling cover up to the threaded studs and SW105 RECEIVER turn until studs protrude through the holes in the BLACK SUPPLY ceiling cover (Figure 18). WIRE 8. Secure the ceiling cover in place by installing two WHITE RECEIVER WIRE lockwashers and two knurled knobs (supplied) WHITE SUPPLY WIRE BLACK RECEIVER WIRE...
Page 10
6. Position the switch housing assembly onto the Switch Housing/Downlight switch housing plate and secure using the three Installation switch housing screws (supplied) (Figure 22). 7. Install three 40-watt (max.) candelabra light bulbs NOTE: Perform the steps in this section only if (not supplied) into the downlight sockets (Figure 22).
Page 11
Setting Operating Installation Frequency of Wall Control of Wall Control and Receiver (Figure 24) WARNING Your wall control and receiver have code switches which must be set in one of 16 possible code Turning off wall switch is not sufficient. To avoid combinations.
5. To turn the lights on and off, press and release the Operating Your U/L (uplight) button or the D/L (downlight) button (if Ceiling Fan downlight kit is added to fan). The lights will turn on at the light level previously set (see Step 4). IMPORTANT Red light turns on when any button is pressed.
NOTE: Periodically check the tightness of the accessories not designated for use with this product knurled knobs securing the light kit glass in the by Emerson Electric Co. could result in personal light kit adapter. Tighten if necessary. injury or property damage.
You will be responsible for all insurance, freight or other transportation charges to our factory or authorized service center. Your Emerson Air Comfort Ceiling Fan should be properly packed to avoid damage in transit since we will not be responsible for any such damage.