Optional Installation Of No-Light Cover - Emerson CURVA CF252LGRT00 Instructions Manual

7. Optional Installation of No-Light Cover

NOTE: To use the No-Light Cover, the LED Light
Fixture Assembly MUST NOT Be Installed, or the LED
Light Fixture Assembly MUST Be Removed.
7.1
WARNING
!
Turning off wall switch is not sufficient. To avoid possible
electrical shock, be sure electricity is turned off at the
main fuse box before wiring. All wiring must be in
accordance with National and Local codes and the ceiling
fan must be properly grounded as a precaution against
possible electrical shock.
Removal of the Glass from the Lower Housing:
Rotate the Glass counter-clockwise and remove from the
Lower Housing (Figure 28).
Store the Glass in a safe place for future use.
7.2
Remove one of the three M4 x 10 mm Pan Head Screws
from the LED Light Fixture Assembly (Figure 29).
Loosen the remaining two M4 x 10 mm Pan Head Screws
in the key hole slots (Figure 29).
Rotate the LED Light Fixture Assembly counter-clockwise
for removal.
Replace the M4 x 10 mm Pan Head Screw previously
removed and tighten all three screws.
LOWER
HOUSING
Figure 28
LOWER
HOUSING
LED LIGHT FIXTURE
ASSEMBLY
M4 x 10 mm PAN HEAD SCREW
Figure 29
Please contact 1-800-654-3545 for further assistance
17
GLASS
emersonfans.com
U.L. Model No.: CF244L & CF252L