Electronic Clock; Electronic Timer - Caple CR 9201 Instruction Manual

Electronic clock

The programmer is equipped with an
electronic clock with lighted numbers
which indicates hours and minutes.
Upon immediate connection of the oven
or after a power cut, three zeros will
flash on the programmer panel.
To set the hour it is necessary to push
the button and then the
button until you have set the exact hour
(fig. 5.2).
Another way is to simultaneously push
the two buttons and at the same
time push the
Nota: Changing the hour button
deletes any cooking program.
Normal cooking without the
use of the programmer
To manually use the oven, that is, with-
out the aid of the programmer, it is nec-
essary to cancel the flashing AUTO by
pushing the button
switched off and the symbol
on - Fig. 5.3).
Attention: If the AUTO symbol is steady
a cooking program has already been
programmed, by pushing the button
you have cancelled of the program and
the switched to manual.
If the oven is switch on, you must switch
off manually.
Fig. 5.3
22
(fig. 5.2)
or
or button.
(AUTO will be
will go

Electronic timer

The timer program consists only of a
buzzer which may be set for a maximum
period of 23 hours and 59 minutes.
If the AUTO flashing push the
ton.
To set the time, push the
and the or
desired time in the panel (fig. 5.4).
Having finished the setting, the clock
hour will appear on the panel and the
symbol will be lighted.
The countdown will start immediately
and may be seen at any moment on the
panel by simply pressing the button
.
At the end of the time, the
will be switched off and an intermittent
buzzer will go off; this can be stopped
by pressing one of any of the buttons.
Setting the frequency of
the audible signal
The selection from 3 possibilities of
sound can be made by pressing the
button.
A
U
T
O
Fig. 5.4
but-
button
until you obtain the
symbol