Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Caple CR9202 Culina
Summary of Contents for Caple CR9202 Culina
- Page 1 INSTRUCTIONS BOOKLET mod.
- Page 2 GENERAL INFORMATION RECCOMANDATIONS AND PRECAUTIONS DESTINED TO THE END USER ENVIRONMENT PROTECTION ATTENTION: - Before using the appliance, do not forget to remove the plastic Packing disposal films protecting some parts of the appliance (facia-panel, parts in stainless steel, etc.) Sort packing into different materials (cardboard, polystyrene - Do not use the appliance as a space heater.
- Page 3 USE OF THE ELECTRIC OVEN WORK-TOP USE USING GAS BURNERS The first time the oven is used, it may give off acrid smells, caused The following symbols are on the control panel next to each knob: by the first heating of isolating panels glue surrounding the oven (it is necessary to heat up the oven at the maximum - Black circle gas off...
- Page 4 – NATURAL CONVECTION OVENS ATTENTION: The oven is fitted with: The temperature shown on the control panel corresponds to the • a lower heating element; temperature in the oven centre only when the functions selected • an upper heating element. It is possible to select the desired temperature into the oven by turning clockwise the thermostat knob and depending on the models, one or more functions:...
- Page 5 Display USE OF THE GRILL 4-figures, 7-segments diplay for cooking times and time of day. Cooking time and manual function saucepan symbol Automatic function AUTO Install the grid on the third shelf from the oven bottom, at about Minutes counter bell symbol 12 cm from the surface.
- Page 6 Sound signal CARE AND MAINTENANCE The sound signal starts at the end of a programme or of the minutes counter function and it lasts for 15 minutes. To stop it, push any one of the functions buttons. Start programme and check Before cleaning the appliance, disconnect the gas general The programme starts 4 seconds after it has been set.
- Page 7 WARNINGS INSTRUCTIONS DESTINED TO THE USER The technical data are indicated on the data nameplate placed on the inside of the front appliance drawer . The adjustment conditions are stated on the label applied on the packaging and on the appliance. Do not use the oven door handle to move the appliance, such as OVERALL DIMENSIONS (mod.
- Page 8 Connection to the cooker should be made with an approved GAS CONNECTING appliance flexible connection to BS 669. Models for use with LPG should be fitted with a hose suitable for LPG and capable of withstanding 50mbar pressure. A length of 0.9 to 1.25m is recommended.
- Page 9 MINIMUM FLOW ADJUSTMENT FOR WORK-TOP TAPS REPLACEMENT OF THE CABLE In order to adjust the minimum, act as follows: switch the burner In case the cable is damaged, replace it in accordance with the on, and turn the knob towards the minimum flow position following instructions: Remove the knob from the tap, introduce a little screwdriver in - open the box of the supply board as described on the picture...
- Page 10 TAPS REPLACEMENT Act as follows: switch the appliance off, and close the general tap open the work-top and disassemble also the control panel as described on the previous paragraph. Unscrew screw nut D of the gas tube supplying the burner. Unscrew screw V fixing the tap to the bridle and remove it (see picture 22).
- Page 11 For your safety This appliance is marked according to the European directive The product should only be used for its intended purpose which 2002/96/EC on Waste Electrical is for the cooking of domestic foodstuffs. and Electronic Equipment (WEEE). Under no circumstances should any external covers be removed By ensuring this product is disposed of correctly, you will help for servicing or maintenance except by suitably qualified personnel.