Agilent Technologies InfiniiVision 2000 X-Series User Manual page 125

Provide Correct Matching
N O T E
Many video signals are produced from 75
sources, a 75
oscilloscope input.
4 Press the sync polarity softkey to set the Video trigger to either positive
5 Press the Settings softkey.
6 In the Video Trigger Menu, press the Standard softkey to set the video
Standard
NTSC
PAL
PAL-M
SECAM
7 Press the Auto Setup softkey to automatically set up the oscilloscope for
Agilent InfiniiVision 2000 X-Series Oscilloscopes User's Guide
terminator (such as an Agilent 11094B) should be connected to the
( ) or negative (
standard.
The oscilloscope supports triggering on the following television (TV) and
video standards.
the selected Source and Standard:
• Source channel vertical scaling is set to 140 mV/div.
• Source channel offset is set to 245 mV.
• Source channel is turned on.
Trigger type is set to Video.
•
Video trigger mode is set to All Lines.
•
Display Grid type is set to IRE (when Standard is NTSC) or mV (see
•
select the grid type"
sources. To provide correct matching to these
) sync polarity.
Type
Interlaced
Interlaced
Interlaced
Interlaced
on page 104).
Triggers
Sync Pulse
Bi-level
Bi-level
Bi-level
Bi-level
9
"To
125