Advertisement
STEP4: INSTALL LiFTBRACKET ASSEMBLY
(SEEFIGURE 3)
o Assemble t heliftbracket a ssembly t otheliftframe
assembly u sing two5/8"washers (ll)and1/8"x 1ol/4"
cotterpins(AA),
LIFT
118"x 1-114"
ASSEMBLY
COTTER
r_.
(AA)
I
"4
I
I
d
LIFT FRAME
ASSEMBLY
FIGURE
3
STEP 6: INSTALL LiFT STRAP ASSEMBLIES
(SEE FIGURE 5)
Loosen the bolts and nuts on the lift strap
assemblies 1/4 turn or until the straps will slide back
and forth, You wilt retighten them later in step 26,
Turn the lift strap assemblies as shown, Insta!l each lift
strap assembly to an arm of the lift bracket assembly
and then secure with a small 1/2" washer (GG) and a
short hairpin cotter (Z),
Position the lower end of each lift strap assembly to
the outside of the lift frame, Fasten to the upper front
holes in the lift frame using a 1/2" x 1" clevis pin (MM),
1/2" long spacer (X) and short hairpin cotter (Z) for
each assembly,
NOTE: The lift strap assemblies may be installed in the
rear mounting holes of the lift frame to increase the Jilt
height, but this will also increase the lifting effort, The
front holes give a lift height of about 6ol/2" and require 28
Jbs,of force to lift a 150 Ib load, The rear holes will give a
lift height of about 8-1/2" and require 35 Ibs, of force,
STEP 5: INSTALL TILT ANCHOR ASSEMBLY
(SEE FIGURE 4)
Assemble the tilt anchor assembly to the lift bracket
assembly using two 1/2" x 1" hex bolts (C) and 1/2"
nylock jam nuts (Q), Tighten.
SHORT HAIRPIN
ARM
COTTER (Z)
"\\..
/
112"WASHER
_... _../
(SMALL) (GG)
TILT ANCHOR
ASSEMBLY
1/2" x 1"
HEX BOLT (C)
LIFT
BRACKET
1/2" NYLOCK
JAM NUTS
(Q)
I
I
I
112" x 1"
I
HEX BOLT (C)
LIFT STRAP
SHORT
ASSEMBLY
HAIRPIN
/ ,..
COTTER (Z)
"%"0
1/2" SPACER (X)
X
UPPER FRONT
1/2" x 1"
MOUNTING
HOLE
CLEVIS PIN (MM)
FIGURE 5
Bucket removed for clarity
FIGURE 4
Advertisement
